HP S230tm Touch manual Cleaning the monitor, Removing the monitor stand

Page 20

Cleaning the monitor

For optimal performance you should regularly clean the touch screen and the touch screen reflectors around the inside of the front bezel.

1.Turn off the monitor and unplug the power cord from the back of the unit.

2.Dust the monitor by wiping the screen and the cabinet with a soft, clean antistatic cloth.

3.For more difficult cleaning situations, use a 50/50 mix of water and Isopropyl alcohol.

CAUTION: Spray the cleaner onto a cloth and use the damp cloth to gently wipe the screen surface. Never spray the cleaner directly on the screen surface. It may run behind the bezel and damage the electronics.

CAUTION: Do not use cleaners that contain any petroleum based materials such as benzene, thinner, or any volatile substance to clean the monitor screen or cabinet. These chemicals may damage the monitor.

Removing the monitor stand

You can remove the monitor panel from the stand to install the panel on a wall, a swing arm, or other mounting fixture.

CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected. Also disconnect the USB and audio cables connected to the monitor.

1.Disconnect and remove the signal, power, USB, and audio cables from the monitor.

2.Lay the monitor face down on a flat surface covered by a clean, dry cloth.

3.Pull the easel stand up to the vertical position (1), remove the two screws that attach the stand to the monitor (2), and then lift the easel stand off the monitor (3).

WARNING! The easel stand is spring loaded so be sure to hold it firmly in a vertical position so that it does not snap back and hit your hand while removing the screws.

14 Chapter 2 Setting up and using the monitor

Image 20
Contents HP EliteDisplay S230tm Touch Monitor First Edition October Document Part Number About this guide Iv About this guide Table of contents Reference guides Product support Product features HP Touch MonitorPage Setting up and using the monitor Rear componentsConnecting the cables Page Page Page Adjusting the monitor tilt Front and side components Turning on the monitor Using the touchscreen HP watermark and image retention policyOne-finger slide TappingScrolling Pinching/stretchingRotating Edge swipes Windows 8 onlyTop-edge and bottom-edge swipe Right-edge swipeLeft-edge swipe Cleaning the monitor Removing the monitor standMounting the monitor Installing a cable lock Locating the rating labelUsing the webcam Installing YouCam from the discCapturing webcam video and snapshots Having a video chat or making conference callsPage Product support Finding more informationReference guides Technical specifications HP S230tmRecognizing preset display resolutions HP S230tmEnergy saver feature Entering user modes