HP E221c manual Removing the Monitor Stand

Page 21

Removing the Monitor Stand

You can remove the monitor panel from the stand to install the panel on a wall, a swing arm, or other mounting fixture.

CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected. Also disconnect all USB cables connected to the monitor.

1.Disconnect and remove the signal, power, and USB cables from the monitor.

2.Lay the monitor face down on a flat surface covered by a clean, dry cloth.

3.Pivot the stand 45 degrees clockwise and remove the lower right mounting screw from the back of the monitor, then pivot the stand 45 degrees counter-clockwise and remove the lower left mounting screw from the back of the monitor.

4.Remove the two upper mounting screws (1) then lift the stand off the monitor (2).

Removing the Monitor Stand 15

Image 21

Contents HP EliteDisplay Webcam Backlit LCD Monitor First Edition May Document Part Number About This Guide Iv About This Guide Table of contents Energy Saver Feature HP LCD Monitor Product FeaturesPage Unfolding the Monitor Setting Up the MonitorComponent Function Rear ComponentsConnecting the Cables Page Page Page Control Function Front Panel ControlsAdjusting the Monitor Page Setting Up the Monitor Turning on the Monitor Connecting USB Devices Removing the Monitor Stand Mounting the Monitor Locating the Rating Labels Installing a Cable LockInstalling YouCam from the Disc Using the WebcamCapturing Webcam Video and Snapshots Having a Video Chat or Making Conference CallsPage Installing HP MyRoom from the Disc Using HP MyRoomDownloading HP MyRoom from the Internet Creating a HP MyRoom AccountFinding More Information Reference GuidesProduct Support E221c Model Technical SpecificationsE221c Model Recognizing Preset Display ResolutionsEntering User Modes Energy Saver Feature