HP LE2002xm 20-inch manual Setting Up the Monitor, Attaching the Monitor Base

Page 9

2 Setting Up the Monitor

To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other attached devices, then follow the instructions below.

Attaching the Monitor Base

1.Lift the base from the monitor box and set it on a flat surface such as a table top.

2.Using both hands, lift the monitor from its box, position the pedestal over the base, and press down firmly to lock it in place. Be sure the base is securely locked in place and adjust the tilt angle to the desired position.

CAUTION: Do not touch the surface of the LCD panel. Pressure on the panel may cause non- uniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover to its normal condition.

Figure 2-1Attaching the Monitor Base

NOTE: To remove the base, press inward on the tab in the center of the underside of the base and pull the base from the pedestal.

ENWW	Attaching the Monitor Base 3

Image 9

Contents User Guide Second Edition December Document Part Number About This Guide Iv About This Guide Table of contents Enww HP LCD Monitors Product FeaturesEnww Attaching the Monitor Base Setting Up the MonitorComponent Function Rear ComponentsConnecting the Cables 5Installing the Cable Management Clip Setting Up the Monitor 1Monitor Front Panel Controls Front Panel ControlsTurning on the Monitor Adjusting the MonitorMounting the Monitor Removing the Monitor Pedestal BaseInstalling a Cable Lock Finding More Information 1LE1902x Specifications Technical Specifications2LE2002x and LE2002xm Specifications LE1902x ModelLE2202x Model Recognizing Preset Display ResolutionsLE1902x Model LE2002x and LE2002xm Models6Factory Preset Modes Energy Saver FeatureEntering User Modes LE2202x ModelEnergy Saver Feature