6 Power cord set requirements
The
The
Power cord sets for use in other countries and regions must meet the requirements of the country or region where the tablet is used.
Requirements for all countries
The following requirements are applicable to all countries and regions:
●The length of the power cord set must be at least 1.0 m (3.3 ft) and no more than 2.0 m (6.5 ft).
●All power cord sets must be approved by an acceptable accredited agency responsible for evaluation in the country or region where the power cord set will be used.
●The power cord sets must have a minimum current capacity of 10 amps and a nominal voltage rating of 125 or 250 V AC, as required by the power system of each country or region.
●The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard Sheet C13 connector for mating with the appliance inlet on the back of the tablet.
Requirements for specific countries and regions
Country/region | Accredited agency | Applicable note number |
|
|
|
Australia | EANSW | 1 |
|
|
|
Austria | OVE | 1 |
|
|
|
Belgium | CEBC | 1 |
|
|
|
Canada | CSA | 2 |
|
|
|
Denmark | DEMKO | 1 |
|
|
|
Finland | FIMKO | 1 |
|
|
|
France | UTE | 1 |
|
|
|
36 | Chapter 6 Power cord set requirements |