ASRock B85iCafe4 manual Onboard Headers and Connectors, Pwrbtn Power Switch

Page 27

B85iCafe4

2.6 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage to the motherboard.

System Panel Header

(9-pin PANEL1)

(see p.10, No. 17)

PLED+ PLED-

PWRBTN#

GND

1

GND RESET#

GND HDLED-

HDLED+

Connect the power switch, reset switch and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables.

PWRBTN (Power Switch):

Connect to the power switch on the chassis front panel. You may configure the way to turn off your system using the power switch.

RESET (Reset Switch):

Connect to the reset switch on the chassis front panel. Press the reset switch to restart the computer if the computer freezes and fails to perform a normal restart.

PLED (System Power LED):

Connect to the power status indicator on the chassis front panel. The LED is on when the system is operating. The LED keeps blinking when the system is in S1/S3 sleep state. The LED is off when the system is in S4 sleep state or powered off (S5).

HDLED (Hard Drive Activity LED):

Connect to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data.

The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assignments are matched correctly.

English

23

Image 27
Contents Page Disclaimer Copyright NoticeContents Page Introduction Package ContentsCPU SpecificationsLAN Bios Certifica Unique Features ASRock Internet Flash ASRock Crashless BiosASRock XFast RAM ASRock OMG Online Management GuardASRock On/Off Play Technology ASRock Fast BootASRock Interactive Uefi ASRock Restart to UefiASRock Easy Driver Installer ASRock FAN-Tastic TuningUSB2 Motherboard LayoutNo. Description I/O Panel Activity / Link LED Status Description Installation Installing the CPU English English Installing the CPU Fan and Heatsink Dual Channel Memory Configuration Installing Memory Modules DimmEnglish PCI slots Expansion Slots PCI and PCI Express SlotsCLRCMOS1 Jumpers SetupPwrbtn Power Switch Onboard Headers and ConnectorsHeader can support two ports Front Panel Audio Header Pin HDAUDIO1 See p.10, No ATX Power Connector Pin ATXPWR1 See p.10, No Print Port Header Pin LPT1 See p.10, No Utilities Menu Installing DriversRunning The Support CD Drivers MenuOperation Mode TuningInstalling A-Tuning Using A-TuningXFast RAM ToolsSystem Info OC TweakerTech Service System Requirements Intel Rapid Start TechnologyConfiguring Rapid Start Setup GuideEnglish Using Rapid Start English Intel Smart Connect Technology Installing ASRock Smart Connect Utility Click Apply to enable Smart Connect Using Smart Connect English Style Installing Start8Configuring Start8 Start8Control ConfigureAbout DesktopUefi Menu Bar IntroductionEND Navigation KeysMain Screen Active Page on EntryUefi Guide Intel Turbo Boost Technology CPU Configuration CPU RatioOC Tweaker Screen Intel SpeedStep TechnologyDram Timing Configuration Load XMP Setting Long Duration Power LimitShort Duration Power Limit GT Voltage ModeDram Frequency Dram Configuration Dram TweakerRAS# to CAS# Delay tRCD Dram Reference ClockWrite to Read Delay tWTR Command Rate CRWrite Recovery Time tWR RAS to RAS Delay tRRDTRDRDDD TCKETRDRD TRDRDDRFivr Switch Frequency Offset Command Tri StateMRC Fast Boot Fivr Configuration Fivr Switch Frequency SignatureCPU Override Voltage CPU Integrated VR FaultsCPU Integrated VR Efficiency Mode Voltage Configuration Dram VoltagePCH 1.05V Voltage Advanced Screen CPU Configuration Intel Virtualization Technology Package C State SupportCPU Thermal Throttling No-Execute Memory ProtectionChipset Configuration Front Panel Restore on AC/Power LossRender Standby Onboard HD AudioSata Controllers Storage ConfigurationSata Mode Selection Sata Aggressive Link Power ManagementIntel Rapid Start Technology Intel Smart Connect Technology Super IO Configuration Acpi Configuration RTC Alarm Power On USB Keyboard/Remote Power OnUSB Mouse Power On Legacy USB Support USB ConfigurationUSB Controller USB 3.0 ControllerTools Dehumidifier Function Network ConfigurationInternet Setting Uefi Download ServerDehumidifier CPU Fan Setting Save User DefaultLoad User Default Over Temperature Protection CPU Fan 1 & 2 SettingChassis Fan 1 Setting Chassis Fan 2 SettingSetup Prompt Timeout Boot ScreenFast Boot Boot From Onboard LANAddOn ROM Display Boot Failure GuardBoot Failure Guard Count Full Screen LogoLaunch PXE OpROM Policy Launch Storage OpROM PolicyLaunch Video OpROM Policy Security Screen Supervisor PasswordUser Password Secure BootExit Screen Contact Information