Place the SIM card with the chip facing downwards and slide it into its housing. Make sure that it is correctly inserted. To remove the card, press it and slide it out.
one touch 217D, two SIM cards can be inserted. n is for SIM1, o is for SIM2.
Removing and installing the battery
Charging the battery
Connect the battery charger to your phone and mains socket respectively.
•The charging may take about 20 minutes to start if the battery is flat.
•Be careful not to force the plug into the socket.
•Make sure the battery is correctly inserted before connecting the charger.
•The mains socket must be near to the phone and easily accessible (avoid electric extension cables).
•When using your telephone for the first time, charge the battery fully
(approximately 3 hours). You are advised to fully charge the battery ( 
/
).
•To reduce power consumption and energy waste, when battery is fully charged, disconnect your charger from the plug; switch off Bluetooth when not in use; reduce the backlight time, etc.
The charge is complete when the animation stops.
1.2Power on your phone
Hold down the 
/
key until the telephone powers on, type in your PIN code if necessary and then confirm. The main screen is displayed.
If you do not know your PIN code or if you have forgotten it, contact your network operator. Do not leave your PIN code with your telephone. Store this information in a safe place when not in use.
If cell broadcast messages are displayed, you can browse through them or press 
/
to return to the main screen.
While the phone is searching for a network, "Searching/Emergency" will be displayed.
In the power on screen, you also have access to the functions of "Radio", etc. even if there is no SIM card inserted.
1.3Power off your phone
Hold down the 
/
key from the main screen.
11 | 12 |