2 Getting started ............
2.1Set-up
Removing and installing the back cover
Removing and installing the battery
Inserting and removing SIM1
1
Inserting and removing SIM2
2
Place the SIM card with the chip facing downwards and slide it into its housing. Make sure that it is correctly inserted. To remove the card, push it and slide it out.
ALCATEL 1060D, two SIM cards can be inserted. 1 is for SIM1, 2 is for SIM2.
5
Inserting and removing the TF card
Charging the battery
Connect the battery charger to your phone and mains socket respectively.
•The charging may take about 20 minutes to start if the battery is flat.
•Be careful not to force the plug into the socket.
•Make sure the battery is correctly inserted before connecting the charger.
•The mains socket must be near to the phone and easily accessible (avoid electric extension cables).
•When using your telephone for the first time, charge the battery fully (approximately 3 hours). You are advised to
fully charge the battery ( 
).
•To reduce power consumption and energy waste, when battery is fully charged, disconnect your charger from the plug; reduce the backlight time, etc.
The charge is complete when the animation stops.
2.2Power on your phone
Hold down the 
key until the phone powers on.
2.3Power off your phone
Hold down the 
key from the idle screen.
6
IP4632_ALCATEL 1060D_QG_Eng_GB_05_130520.indd |