HDLED (Hard Drive Activity LED):
Connect to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data.
The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin
Print Port Header | AFD# |
|
ERROR# | GND | |
SLIN# | ||
| PINIT# |
|
(see p.8, No. 33) | 1 |
|
|
| |
|
| SPD7 |
| SPD6 ACK# | |
| SPD5 | BUSY |
| SPD4 | PE |
| SPD3 | SLCT |
| SPD2 |
|
| SPD1 |
|
| SPD0 |
|
| STB# |
|
This is an interface for print port cable that allows convenient connection of printer devices.
USB 2.0 Headers (USB12: see p.8, No. 34)
USB 3.0 Header | PAIntAD- | GND | PAIntASSTX+ | PAIntASSTX- | GND | PAIntASSRX+ | PAIntASSRX- | Vbus | |
| PAIntAD+ | ||||||||
|
|
|
|
|
|
|
| ||
(see p.8 No. 35) |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1 |
|
|
|
|
|
|
|
|
|
Dummy | IntA PB D+ | IntA PB D- | GND | IntA PB SSTX+ | IntA PB SSTX- | GND | IntA PB SSRX+ | IntA PB SSRX- | Vbus |
Chassis Intrusion Header
(2-pin CI2: see p.8, No. 38)
(2-pin CI1: see p.8, No. 41)
Besides four default USB 2.0 ports on the I/O panel, there are three USB 2.0 headers and one USB 2.0 port on this motherboard. Each USB 2.0 header can support two USB 2.0 ports.
Besides two default USB 3.0 ports on the I/O panel, there is one USB 3.0 header on this motherboard. This USB 3.0 header can support two USB 3.0 ports.
This motherboard supports CASE OPEN detection feature that detects if the chassis cover has been removed. This feature requires a chassis with chassis intrusion detection design.
20