2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Plac- ing jumper caps over the headers and connectors will cause permanent damage to the motherboard!
USB 2.0 Headers
(see p.16, No. 29)
(see p.16, No. 30)
(see p.16, No. 31)
(USB8)
(see p.16, No. 28)
USB_PWR
+B
GND DUMMY
1
GND
+A
USB_PWR
Besides two default USB 2.0 ports on the I/O panel, there are three USB 2.0 headers and one USB port on this motherboard. Each USB
2.0header can support two USB 2.0 ports.
USB 3.0 Headers
(19-pin USB3_11_12)
(see p.16, No. 9)
(19-pin USB3_9_10)
(see p.16, No. 10)
Vbus
IntA_PA_SSRX- IntA_PA_SSRX+
GND
IntA_PA_SSTX-
IntA_PA_SSTX+
GND
IntA_PA_D-
IntA_PA_D+
Vbus
IntA_PB_SSRX- IntA_PB_SSRX+
GND
IntA_PB_SSTX- IntA_PB_SSTX+
GND
IntA_PB_D-
IntA_PB_D+
Dummy
1
Besides eight default USB
3.0ports on the I/O panel, there are two USB 3.0 header on this motherboard. Each USB 3.0 header can support two USB 2.0 ports.
Infrared Module Header
(see p.16, No. 37)
T h i s h e a d e r s u p p o r t s a n o p t i o n a l w i r e l e s s transmitting and receiving infrared module.
Consumer Infrared Module Header
(see p.16, No. 32)
This header can be used t o c o n n e c t t h e r e m o t e controller receiver.
31