MSI Big Bang-Marshal (B3) manual Installing the RAID Driver for bootable RAID Array

Marvell RAID

Installing the RAID Driver (for bootable RAID Array)

Important

Only when you set the “AHCI” mode in Integrated Peripherals menu (the default is IDE mode) of mainboard BIOS setup, you have to install the RAID Driver for the SATA devices.

1.After you complete the RAID BIOS setup, boot from the Windows CD, and the Win- dows Setup program starts.

2.Press F6 and wait for the Windows Setup screen to appear.

3.Insert the floppy that contains the RAID driver, press the “S” key to select “Specify Additional Device”.

Note: for Windows Vista/ Windows 7, you can copy the files to a medium (floppy/ CD/ DVD or USB)

Important

Please follow the instruction below to make a SATA RAID driver for yourself.

•Insert the MSI DVD into the DVD-ROM drive.

•Click the “Browse CD” on the Setup screen.

•Copy all the contents in the : \\Storage\Marvell 9128\SCSI miniport driver\Floppy32 or \\Storage\Marvell 9128\SCSI miniport driver\Floppy64

•The driver disk for RAID controller is done.

4.When prompted, insert the medium disk and press Enter. For Windows Vista/ Windows 7:

During the Operating system installation, after selecting the location to install Vista/ Windows 7 click on “Load Driver” button to load RAID drive.

5.You should be shown a list of available RAID controller(s).

6.Select the compatible RAID controller for 32-bit/ 64-bit version system and then press ENTER.

7.The next screen should confirm that you have selected the RAID controller. Press ENTER again to continue.

8.You have successfully installed the RAID driver, and Windows setup should con- tinue.

9.Leave the medium until the system reboots itself. Windows setup will need to copy the files from the medium again after the RAID volume is formatted, and Windows setup starts copying files.

C-8