MSI MS-91F7 manual Installing Memory Modules

MS-91F7

Installing Memory Modules

1.The memory module has only one notch on the center and will only fit in the right orientation.

2.Insert the memory module vertically into the DIMM slot. Then push it in until the golden finger on the memory module is deeply inserted in the DIMM slot. The plastic clip at each side of the DIMM slot will automatically close when the memory module is properly seated.

3.Manually check if the memory module has been locked in place by the DIMM slot clips at the sides.

Important

You can barely see the golden finger if the memory module is properly inserted in the DIMM slot.

Notch

Volt

Important

•To enable successful system boot-up, always insert the memory modules into the DIMM_A1 first.

•If users intend to install two DIMMs, it is highly suggested that these DIMMs are populated in DIMM_A1 and DIMM_B1 for enhanced Dual-Channel mem- ory performance.

•In Dual-Channel mode, make sure that memory modules of the same type and density are installed in different channel DIMM slots.

2-7