Instructions for use
By pressing the button shown in the figure 2, you will be able to control the functions of the extractor
Two achieve better extraction, we recommend switching on the extractor a few minutes before starting to cook (3 - 5 minutes) so that the air flow is continuous and stable when extracting the fumes.
Likewise, keep the extractor switched on for a few minutes when cooking is complete to allow all fumes and odours to be expelled.
Cleaning and maintenance
Before carrying out any cleaning or maintenance activities, ensure that the extractor is disconnected from the mains.
To carry out cleaning and maintenance, follow the Safety Instructions.
Filter cleaning
To withdraw the filters from their locations release the anchoring points. Clean the filter, either by putting it in the dishwasher (see notes) or leaving it standing in hot water to simplify the removal of grease or, if wished, by means of special sprays (protecting the non metallic parts). Once clean, leave it to dry. Important: for the model
Notes: cleaning in the dishwasher with aggressive detergents may blacken the surface of metallic parts, without this affecting its gas retaining properties.
N.B. The filter must be cleaned at least once a month depending on how often the extractor is used. It must be remembered that grease is deposited in the extractor when cooking, whether it is switched on or not.
Cleaning of the extractorº body
The use of warm (40 C approx.) soapy water is recommended. A cloth moistened in this water is used for cleaning the extractor, paying special attention to the grids. Afterwards, dry it using a
Note:
*Never use metallic scouring pads or abrasive products that could damage the surface.
* Do not use scrapers with metallic surfaces such as knives, scissors etc.
Activated charcoal filter
*To install the charcoal filter, the motor anchorage is made to coincide with the anchor points of the activated charcoal filter and turn it clockwise.
*The carbon filter lasts from three to six months depending on the particular conditions of use.
*The activated carbon filter can neither be washed nor regenerated. Once it is exhausted, it must be changed.
*To replace exhausted filters with new ones, withdraw the old one in the reverse order to
that of installation.
Changing Bulbs
*Remove the filter support to acces the bulbs.
*Take care to disconnect the mains beforehand and that the bulbs to be replaced are not hot.
*The maximum bulbs power is 40W.
Tecnical Information
(Fig. 3)
Dimensions | Width = 600 / 900 mm |
| Depth = 280 mm |
| Height = 181 mm |
Electrical characteristics:
REFER TO RATING PLATE