Accesories supplied
1150/ 120 mm reduction.
1Support for tubecover.
4Wall plugs (Ø8 x 40).
4Long bolts (Ø5 x 45).
2Wall plugs (Ø6 x 30).
2Long bolts (Ø4 x 30).
2Ø6,4 x Ø18, washers.
2Screws (Ø3,9 x 13).
2Clips.
Installation
9)Fit the clips (F) to the support (C).
10)Centre the support (C) around the shape marked; trace and drill the fixing points for the wall plugs (E) (Ø6 x 30). Attach the support (C) with the long bolts (D) (Ø4 x 30).
11)Fit the part (B) if the inner tube (not supplied) is Ø120.
12)Attach the inner tube with a clamp (not supplied) to (B) or on to the motor's air outlet vent as the case may be.
13)Once the inner tube is fitted, fit the lower tubecover around the extractor fan outlet and attach the upper tubecover with the screws (G) (Ø3,9 x 13).
Fig. 1 (Page 31)
On installing the kitchen hood make sure that the Safety Instructions set out on page 10 are complied with.
To obtain optimum performance, the external conduct must not be more than FOUR METRES long, have no more than two 90° angles and its diameter must be at least Ø120.
1)Trace and drill the points for fitting the wall plugs onto the wall (A1) (Ø8 x 40). See figure nr. 1.
2)Fit the wall plugs (A1) and screw in the long bolts (A2) (Ø5 x 45) leaving them protruding 5 mm out of the wall.
3)Attach the kitchen hood to the long bolts (A2). Straighten the apparatus and tighten the long bolts.
4)Trace the location of the wall plugs (R) (Ø8 x 40), through the inside of the kitchen hood.
5)Loosen the long bolts (A2) and take the kitchen hood off.
6)Drill into the wall and fit the wall plugs (R).
7)Attach the kitchen hood, tighten the long bolts (A2) and (S) (Ø5 x 45) with the washers
(T) (Ø6,4 x Ø18).
8)Mount the tubecovers. Lift the upper tubecover up to the desired height and mark its shape on the wall. Remove the tubecovers.
Active charcoal filters (Optional) |
|
| |
When exterior gas extraction is not possible, |
| ||
then the kitchen hood may be set to purify the |
| ||
air by recycling it through active charcoal |
| ||
filters. |
| ||
The active charcoal filters have an active life of |
| ||
ENG | |||
between three to six months, depending on | |||
| |||
the individual conditions of use. These filters |
| ||
cannot be washed nor regenerated. They must |
| ||
be replaced once their useful life comes to an |
| ||
end. |
| ||
Fig. 2 (Page 31)
1)Put the filters into the lateral draught section of the motor making the holes in the filters match up (A) with the pivots (B) of the motor carcass. Turn as indicated in the diagram.
2)Remove the tubecovers (E). Fit the diffuser
(C) on to the motor's air outlet vent. Fit the tubecovers back on (E).
13