Installation, General | Lenoxx Electronics 41718L098 specification

INSTALLATION

General

Read this entire instruction manual, as well as the instructions supplied in separate equipment, before starting the installation. Observe and follow all warnings, cautions, instructional labels and tags. Failure to comply with these instructions could result in an unsafe condition and/or premature component failure.

These instructions are intended as a general guide only for use by qualified personnel and do not supersede any national or local codes in any way. The installation must comply with all provincial, state and local codes as well as the National Electrical Code (U.S.) or Canadian Electrical Code (Canada). Compliance should be determined prior to installation.

This unit has been factory charged with a quantity of refrigerant (R22) sufficient for a matched indoor coil and 20 feet of refrigerant tubing. If installed with other indoor sections or with tubing sets other than 20 feet in length, adjustments to the total system charge must be made.

This outdoor unit has been ARI rated with several Arm- strong matching indoor sections for various types of installations. To obtain optimum performance, a matched indoor section must be installed. ARI ratings are based on properly charged systems running at rated indoor cfm levels. Ductwork should be specified to insure the correct indoor airflow is obtainable.

Inspection of Shipment

Upon receipt of equipment, carefully inspect it for possible shipping damage. If damage is found, it should be noted on the carrier’s freight bill. Take special care to examine the unit inside the carton if the carton is damaged. Any concealed damage discovered should be reported to the last carrier immediately, preferably in writing, and should include a request for inspection by the carrier’s agent.

If any damages are discovered and reported to the carrier DO NOT INSTALL THE UNIT, as claim may be denied.

Check the unit rating plate to confirm specifications are as ordered.

Limitations

This unit is designed and approved for outdoor use only.

The outdoor unit must not be installed with any ductwork in the airstream. The outdoor fan is not designed to operate against any additional static pressure.

The unit has been designed to operate within the range of indoor and outdoor temperatures as outlined in Table 1. Following these recommendations will minimize compo- nent failures and maximize system performance.

Optimum Temperature Range

	Outdoor	65° F* (minimum) to
	Outdoor	115° F (maximum)
		115° F (maximum)

	Indoor	62° F db/57° F wb to
	Indoor	90° F db/72° F wb
		90° F db/72° F wb

*If extended run times are anticipated below outdoor temperatures of 65° F, a low ambient kit must be installed.

Table 1

Location of Unit

Install the unit on a solid, level mounting pad. To minimize transmission of vibration, the pad should not be in direct contact with any building walls or foundations.

This unit has been designed to be located outdoors with sufficient clearance for free entrance to the inlet and discharge air openings. Adequate service clearance must also be provided. Refer to Figure 1 for a detailed descrip- tion of minimum clearances. Position the unit to avoid direct contact of water, snow or ice from a roof line overhead.

Avoid placing the unit near quiet areas such as sleeping quarters or study rooms. Normal operating sound levels may be objectionable if the unit is placed near certain rooms.

Electrical Wiring

All field wiring must be done in accordance with the National Electrical Code recommendations, Canadian Electrical Code and CSA Standards, or local codes, where applicable. Refer to the unit rating plate for information needed for wire sizing and branch circuit protection. An adequately sized branch circuit disconnect should be installed, per the NEC, within sight of and readily acces- sible to the unit. Route properly sized copper conductors from the disconnect to the unit high voltage connections at the contactor. A properly sized ground wire must be connected to the ground screw or wire located in the control panel. Two low voltage thermostat wires must be connected to the yellow wires connected to the contactor coil. Use copper conductors only.

Page 2

# 41718L098

41718L098 specifications

Lenoxx Electronics has established a reputation for producing high-quality electronic devices, and the 41718L098 model is no exception. This versatile and user-friendly product serves as an excellent addition to any home or office setup. With an array of features designed to enhance usability and performance, it caters to the needs of a broad audience.

One of the main features of the Lenoxx Electronics 41718L098 is its compact design. This device is engineered to fit seamlessly into various spaces without consuming too much room, making it ideal for small apartments, offices, or dormitories. Its sleek aesthetics also allow for easy integration into contemporary decor.

The 41718L098 boasts advanced connectivity options. With Bluetooth technology, users can easily pair their smartphones, tablets, or laptops for seamless streaming of music and multimedia content. This feature is particularly appealing for those who enjoy entertainment or hosting gatherings, as it allows for effortless audio transmission.

Another highlight of this model is its sound quality. Equipped with high-fidelity speakers, the 41718L098 delivers rich, clear audio suitable for a variety of audio formats. Whether listening to music, watching movies, or engaging in conference calls, users can expect an immersive auditory experience. Additionally, the device incorporates noise-canceling technology, which minimizes background disturbances to further enhance sound clarity.

The user interface is another standout characteristic. Lenoxx has designed the 41718L098 to feature intuitive controls that are easily accessible, allowing users to adjust volume, change tracks, or manage connectivity with minimal effort. The device also includes a visual display that provides important information, such as battery status and connection options, making it user-friendly for all ages.

Moreover, this model is designed with sustainability in mind. Built with energy-efficient components, it consumes less power compared to its competitors, making it an environmentally friendly option.

In summary, Lenoxx Electronics 41718L098 is a compact, feature-rich device with advanced connectivity, superior sound quality, and user-friendly controls. Its attention to sustainability adds to its appeal, making it a smart choice for those seeking reliability and performance in their electronic devices.