Frequently Asked Questions
I cannot close the lid:
If your pressure cooker has been heated without any liquid in it:
The pressure indicator does not move up:
The pressure indicator has lifted up and some steam still escapes from it:
The pressure indicator has lifted up and no steam escapes from the release outlet during cooking:
If steam escapes from around the control module: check:
Steam is leaking around the lid: check:
If one of the security devices is activated (safety valve or seal):
Regular beeps and
I cannot open the lid:
The aspect of the interior has changed:
■Make sure the jaws are fully open before fitting the lid onto the pot.
■Have it checked at any TEFAL Approved Service Centre.
■This is normal during the first few minutes of heating.
■If this condition remains unchanged, check that:
The heat is turned up to the highest position.
The quantity of liquid inside the pressure cooker is sufficient.
The programme selector is not set to 
. The cooker is firmly closed.
■If you have a Clipso Control model or Clipso Vitamin
(model with air release system) once the pressure indicator has moved up, air and steam are normally released during a certain time period (a few seconds to a few minutes).
■Set the programme selector to 
:
-If no steam escapes, put your pressure cooker under cold water to release the steam, then clean the operating valve and release outlet.
-If steam escapes, the pressure level has not been reached yet: set the selector back to the initial position.
■The control module is sufficiently screwed on.
■Good condition and correct installation of the seals on the operating and safety valves.
■The lid closes correctly.
■The seal is correctly fitted onto the lid.
■The seal is clean and not damaged. Replace it if necessary.
■Lid, safety valve and operating valve are clean.
■The edge of the pot is not damaged.
■Turn off the heat source immediately.
■Let the pressure cooker cool down.
■Open the cooker.
■Check and clean the operating valve, steam release outlet, safety valve and seal.
■Check that the timer is correctly fitted onto the control module.
■Check that the pressure indicator is in the low position.
■If not: release the steam from the pressure cooker by cooling it under cold water, if necessary.
■If it is blackened: clean it with a special product for cleaning stainless steel.
■If it shows iridescent glints: clean it with vinegar or a special stainless cleaning product.
23