Makita 4071D dimensions Installing or removing battery cartridge, Charging

Installing or removing battery cartridge	I
*Always switch off the tool before inser-	Set d a t e
tion or removal of the battery cartridge.
	/
To remove the battery cartridge, pull out
the set plate on the tool and grasp both
sides of the cartridge while withdrawing it
from the barrel.
To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into
place. Snap the set plate back into place.
Be sure to close the s e t plate fully before
using the tool.

Do not use force when inserting the battery cartridge.

If the cartridge does not slide in easily, it is not being inserted correctly.

Charging
Plug the fast charger into your power		I-	Vents
source. Insert the battery cartridge so that
the plus and minus terminals on the bat-
tery cartridge are on the same sides as their
respective markings on the fast charger. In-
sert the cartridge fully into the port so that
it rests on the charger port floor.
Check to see that the charging light comes
on. When it goes out, you may remove the
f uIIy charged battery cartridge.		i + l ( - I Terminal markinas I
After charging, unplug the charger from	v\\

the power source.

CAUTION :

Your new battery cartridge is not charged. You will need to change it before use.

If you try to charge a cartridge from a just-operated tool, sometimes the charging light will not come on. If this occurs, let the cartridge cool off for a while. Then re-insert it and try to charge it once more.

When you charge a new battery cartridge or a battery cartridge which has not been used for a long period, it may not accept a full charge. This i s a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it almost completely a couple of times.

*I f you wish to charge two battery cartridges, allow 15 minutes between chargings on the fast charger.

5