Panasonic CQ-DP153W manual Fuse, Wiring Diagram

G Electrical Connections		Speaker Connections
E
N
L
I
S	Caution:	Caution: Please follow the instructions given below. Failure to do so will cause damage to the unit and speakers.
H

•This product is designed to operate with a 12 V DC, negative ground battery system.

11• To prevent damage to the unit, be sure to follow the connection diagram below.

• Strip about 5mm of the lead ends for connection (only non-ISO connector cords).

<Right>

• Use ungrounded speaker only.

• Do not insert the power connector into the unit until the wiring is completed.

(White)

• The maximum speaker input should be 45 W or more.

(If used with the optional

• Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and

L +

+

power amplifier, the speaker input should be higher than the maximum amplifier

-

(White

-

output.)

keep cable terminals free from touching any metal parts.

w/black stripe)

• Remember, if your car has a drive computer or a navigation computer, the data of its memory may be erased

+

+

• The speaker impedance should be 4 - 8 Ω .

when the battery terminals are disconnected.

(Gray)

• This unit uses the BTCL circuit, so each speaker should be connected separately

R -

using parallel vinyl insulated cords.

-

❐ Wiring Diagram

(Gray

• The speaker cords and the power amplifier unit should be kept away (about 30 cm

w/black stripe)

apart) from the antenna and antenna extension cord.

Preamp output connector (rear)

<Wrong>

CQ-DP153W

+

+

L

+

+

L

+

+

+

L (White)

Fuse (15 A) C

L -

-

-

-

-

-

-

R (Red)

C If the fuse (rear panel) blows frequently, they may

Chassis

Antenna

be something wrong with the unit. Consult your

+

+

nearest dealer for service.

+

+

R

+

R

+

+

y Power connector

R -

-

-

-

-

-

-

Ground lead

Battery lead

Chassis

(Black)

BATTERY 15A

To the car battery, continuous +12 V DC

To a clean, bare metallic

(Yellow)

• Never connect the speaker cord to

• Do not use a 3-wire type speaker

• Do not connect more than one

part of car chassis.

the body of the car.

system having a common earth

speaker to one set of speaker

Motor antenna

Power lead

lead.

leads.

ACC

relay control lead

(Dark blue)

(Red)

To ACC power, +12 V DC

(To motor antenna)

Amp. relay control power lead

(Max. 500 mA)

This lead is not intended

(Dark blue/

(Max. 500 mA)

for use with switch actuated

white stripe)

This lead is for connection to the power

power antenna.

amplifier.

Note: The power antenna extends

Note: This lead is used for power

Fuse

control when an external power

automatically when the FM/AM

amplifier is connected. The power

radio mode is selected.

supply of a power amplifier will be

activated when turning on the power of

Use fuses of the same specified rating (15 A). Using different substitutes or fuses with higher ratings, or connecting

this unit.

Speaker lead

the unit directly without a fuse, could cause fire or damage to the unit.

If the fuse replacement fails, contact your nearest authorized Panasonic Service Center.

FRONT SP

REAR SP

(White/

(White)

(Gray/black

(Gray)

(Green/black

(Green) (Violet/black

(Violet)

black

stripe)

stripe)

stripe)

stripe) (–)

(+)

(–)

(+)

(–)

(+)

(–)

(+)

Left speaker	Right speaker	Left speaker	Right speaker
(Front)	(Front)	(Rear)	(Rear)

E

N

G

L

I

S

H

12

16 CQ-DP153W CQ-DP153W 17