Ignore Start Level When Receiving Dim Commands Please note: Every “Dim” command from your remote controller includes a start level embedded in it. The 45602 can be set to ignore the start level that is part of the dim command. Setting parameter 5 to a value of 0 will cause the 45602 to dim or brighten from the start level embedded
in the command.
-Parameter No: 5
-Length: 1 Byte
-Valid Values = 0 or 1 (default 1)
Restoring Factory Defaults
All Configuration Parameters can all be restored to their factory default settings by using your primary controller to reset the device.
Software Fuse
This Lamp Module is designed to protect itself against loads that exceed its maximum power rating. An overload is automatically sensed by the module and all power to the load is shut OFF immediately.
Troubleshooting: Verify that the lamp wattage does not exceed the 300W rating if the module doesn’t seem to work properly. Normal operation can be restored by remote when the load is reduced to the proper rating.
Over-Current Protection
Additional