Wired Remote Controller-Buttons and Display
The wired remote controller is an optional accessory and it is installed on the wall. To use the wired remote controller, refer to an appropriate manual.
Operating mode
ENGLISH
Removing frost indicator 
(Except Cooling Only Models)
Communication error indicator 
On Timer setting
Off Timer setting
Test indicator
Temperature adjustment buttons
Centralized controller indicator
(In case of installing the Centralized controller)
Temperature setting
Fan speed
Air flow direction
Filter Sign indicator
On/Off & Timer
Set/Cancel button
On/Off indicator
On Timer button
Off Timer button
Test button
Fan speed adjustment |
button |
Swing button |
Filter Reset button |
Mode selection button
Note ◆ Test button is for your installation specialist. You must NOT press it.
◆After cleaning the air filter, press the filter reset button. Then the wired remote controller will display the FILTER SIGN indicator when the time to clean the air filter; refer to page 11 or 12.
◆The heating mode(
) is not selected in cooling only models.