Install the Case in the Window
5 | A | Open the window and mark the centerline of | |
the window stool. | |||
| |||
|
| Carefully place the case on the window stool | |
| B | ||
|
| and align the center mark on the bottom front | |
|
| ||
|
| with the centerline of the stool. | |
|
| Pull the window down behind the top | |
| C | ||
|
| mounting rail. | |
|
|
FAdjust the bolt and the nut in each support so that the case is installed with a slight tilt to the outside. Use a level; about 1/3 bubble will be the correct case slant to the outside.
GSecure the case to the window stool by using 3 type B screws.
Safety Instructions
NOTE: Do not shut the window so tightly that movement of the accordion panels is restricted.
DLoosely assemble the sill supports.
INDOOR |
| OUTDOOR |
|
| Sill support |
| Bolt | Nut |
|
|
ESelect the position that will place the sill supports near the outermost point on the sill. Attach the sill supports to the case track hole in relation to the selected position using 2 type A screws in each support.
Sill
support
HPull the accordion panels to each window sash track. Attach them on each side to the window sash and the window stool using 4 type C screws.
Operating Instructions Installation Instructions Troubleshooting Tips
Frame guide
11