Panasonic RX-D29 operating instructions Listening to radio broadcasts

Listening to radio broadcasts

Normal tuning

2 1 3 4

1 Press [TUNER/BAND –AUTO PRESET] to select “FM” or “AM”.

(Unit comes on.)

2 (Omit this step if using the remote control)

If “” is on the display, press [TUNE MODE] to clear it.

3 Press [– / ] or [ / +] to tune to the desired station.

Automatic tuning

Press and hold [–/ ] or [/+] then release when the frequency display starts to change. A station with good reception is automati- cally selected and the process stops.

To stop automatic tuning, press [–/ ] or [/+] again.

Note

Automatic tuning may stop on a frequency where there is no station if there is interference. Press [–/ ] and [ /+] to tune if this occurs.

4 Adjust the volume.

To improve reception

FM: Extend the whip antenna and adjust its direction.

AM: Adjust the position of the unit.

If noise is excessive in the FM stereo mode

Press [PLAY MODE] on the remote control. (“MONO” lights up.)

Sound will be produced in monaural, but this also reduces noise.

Press the button again to cancel. (“MONO” goes out.)

Preset tuning

Preset the stations (20 FM and 12 AM) to make tuning simpler.

2

1

RX-D29

2 1 3

RX-D27

Automatic presetting

Do the following once each for FM and AM.

Preparations: Press [TUNER/BAND –AUTO PRESET] to select “FM” or “AM”.

Press and hold [TUNER/BAND –AUTO PRESET] on the main unit until “AUTO” is displayed.

The tuner presets stations it can receive into the channels.

Manual Presetting

Remote control only

Presets one station at a time.

1 Press [PGM/CLEAR].

2 While “” is flashing (about 10

seconds)

Press the numbered buttons to select a channel.

To select channel 10 or higher

e.g.12: [>10] → [1] → [2]

=

Repeat the above to preset other stations.

The station occupying a channel is erased if another station is preset in that channel.

To listen to preset channels

1Press [TUNER/BAND –AUTO PRESET] to select “FM” or “AM”.

2(Omit this step if using the remote control)

Press [TUNE MODE] to display

“”.

3Press [– / ] or [ / +] to select the desired channel.

(FM:1-20, AM:1-12)

Remote control:Preset channel [/ ALBUM]( PRESET TUNE)

or [ALBUM / ](PRESET TUNE )

6

RQTT0585