Paragon W13, WTNFII-19, W14, W18, WTNFII-10 manual Cplt Dela, Elec, Eth, Fail, Fth, Ftl, Full, Lock

CPLT

DELA

minutes.

Complete This means the firing completed as programmed.

Delay DELA is a timer that starts the kiln later. Delay time appears in hours and

˚F 1 Temperature This prompt which appears in Ramp-Hold programming, is asking for

a target temperature. The number is to remind you which segment will use this target temperature.

ELEC Electronics The Sentry circuit board is rated for operation at temperatures up to

158˚F/70˚C. When the circuit gets hotter, the Sentry shuts off. The ELEC option tells you how hot the circuit board is.

ETH

Electronics Too Hot The Sentry circuit board is too hot, so the kiln was shut off.

FAIL Failed The thermocouple failed. This can be due to a broken thermocouple, loose

thermocouple connection on the back of the Sentry, disconnected thermocouple wire, or a defective controller.

FTH

all.

Failed to Heat The kiln cannot heat as fast as you programmed or is not heating at

FTL	Firing Too Long The temperature rise is less that 27ْF/15ْC per hour and the firing
	hours longer than the current segment was programmed.
time is four

FULL

Full Speed The rate, or temperature change per hour, is maximum.

Hd 1 Temperature Hold When this message appears during Ramp-Hold

programming, it is asking you if you want to hold, or maintain, the target temperature of that segment. If so, enter the length of hold time in hours and minutes (i.e. 1 hour 20 minutes = 01.20). The number after Hd is the segment number. Each segment in a Ramp-Hold firing is numbered starting with 1.

	HOLd	Temperature Hold		When this message appears during programming, it is asking
if you want to hold, or maintain, the target temperature. If so, enter the length of hold time in hours
and minutes (i.e. 1 hour 20 minutes = 01.20). When HOLd appears in the program review, it is
showing how much hold time has been entered.
	HtdE	High Temperature Deviation			The temperature is above the temperature deviation
	setting in the	TEDE option.
		Computer ID	The ID option is for connection the Sentry to a personal computer.
	ID
	IdLE	Ready to Begin The Sentry must display the idle message before you can begin firing
or programming.
	LOCK	Program Lock	With this option activated, a stored program cannot be altered or
removed from memory.
	LTdE	Low Temperature Deviation			This message appears when the kiln is below the

temperature deviation setting in the TEDE option.

8