Pelco installation instructions CA1750 Mount Adapter Installation Instructions C209M 4/98

CA1750 Mount Adapter

Installation Instructions

C209M (4/98)

®

1.0 DESCRIPTION

2.0 INSTALLATION

CAUTION: Be careful not to damage the cam- era by screwing the adapter too far onto the threaded stud. As soon as the stud threads appear through the adapter cap- tive nut, tighten the knurled nut.

The CA1750 Mount Adapter is used when installing a bottom-mount camera on a BS1750, CM1750, CM1750S, or TB1750 mount only when the mount is attached to a ceiling. Use of the adapter, in this situation, will allow the camera to be mounted in its correct orientation, rather than being inverted.

To install the adapter (refer to Figure 1):

1.Place the camera inside the adapter and align the camera mount boss with the elongated hole in the adapter.

2.Attach the camera to the adapter with the provided 1/4-20 bolt and washers.

3.Attach the adapter with camera to the 1/4-20 threaded stud on the installed mount swivel head. Tighten the knurled nut on the mount against the adapter.

Figure 1. CA1750 Mount Adapter

Pelco • 300 W. Pontiac Way, Clovis, CA 93612-5699 • USA • Pelco Online @ http://www.pelco.com In North America and Canada: Tel (800) 289-9100 • FAX (800) 289-9150 • DataFAX (800) 289-9108 International Customers: Tel (1-559) 292-1981 or FAX (1-559) 348-1120 • DataFAX (1-559) 292-0435