Charging
Note:
Check to ensure that the on/off switch 6 has been slid back (to the position "0") before starting the charging process.
•Place the hand vacuum cleaner from above into the wall holder 3 so that the barrel plug 5 slips into the socket on the hand vacuum cleaner.
The charge indicator lamp 7 glows red and the charging process begins.
IMPORTANT:
•When the hand vacuum again has enough ener- gy to vacuum, the charge indicator lamp 7 glows green. This does not mean that the batte- ries are fully charged. When the charge indica- tor lamp 7 glows green, it means the batteries are charged to about 80%.
•When the charging process is complete, which may take 12 to 15 hours for completely dis- charged batteries, the device switches over to a trickle charge (maintenance function) automati- cally. Nevertheless, in order to avoid possible damage to the batteries, do not leave the appli- ance permanently connected to the power adapter 4.
•Reconnect the appliance with the power adap- ter 4 when the suction power has become noticeably weaker.
Note:
The hand vacuum cleaner can also be charged directly via the power adapter 4. For this, remove the barrel plug 5 with a slight twist from the wall holder 3 and insert it into the socket on the hand vacuum cleaner.
Operation
Warning:
The suction opening must always be open and unblocked. Blockages lead to overheating and da- mage to the motor.
Tips:
•Make certain that the dust filter 9 is always inserted before using the appliance.
•As the maximum, suck up only as much liquid as will fill the dirt container 0 to the MAX mark.
1.Take the hand vacuum cleaner from the wall hol- der 3 or, if you do not use the wall holder 3, remove the barrel plug 5 from the socket.
2.If required, place the appropriate nozzle into the suction opening:
•the crevice nozzle 2, to clean narrow and difficult to reach locations.
•the wet suction nozzle 1 to vacuum liquids up.
Note:
After you have vacuumed up liquids, immediately clean the dirt container 0. Otherwise bacteria and microbes could form in it! Ensure that the dust filter 9/der dust filter bag is completely dry before using the appliance again.
3.To switch the appliance on, slide the on/off switch 6 forwards.
4.When you have finished using it, slide the on/ off switch 6 to the rear.
Place the hand vacuum in the wall holder 3 and start the charging process when the vacuum power has become noticeably weaker.
- 5 -