American Standard 7038.400 POP-UP Drain, Remove Flange, Install Drain from, Below Fixture

3 POP-UP DRAIN

Remove CLEAR PLASTIC COVER (1).

Remove CARDBOARD SPACER (2) from under DRAIN POP-UP (3).

Tighten TAILPIECE (4) on DRAIN BODY before installing DRAIN BODY. Fig. B.

Fig. A.

1

3

2

Fig. B.

DRAIN

BODY

4

4 REMOVE FLANGE

Thread FLANGE (1) counter-clockwise and remove FLANGE (1) and FOAM GASKET (2) from drain

body. Fig. A.

Thread LOCKNUT (3) clock-wise to bottom of drain body. Push GASKET (4) down against LOCKNUT (3). Fig. B.

Fig. A.

1

2

Fig. B.

4

3

5	INSTALL DRAIN FROM
	BELOW FIXTURE

From under side of BIDET install DRAIN BODY (1) up through drain outlet.

Note: No plumber’s putty or caulk is required.

The CABLE ATTACHMENT POINT (2) must face towards the rear of the BIDET.

Install FOAM GASKET (3) and FLANGE (4) onto drain body from above BIDET and tighten FLANGE (4) firmly.

6

4

3

DRAIN

OUTLET

1

2

TIGHTEN LOCKNUT

Tighten LOCKNUT (1) firmly with Adjustable Wrench or Channel Locks.

1

7 FLANGE GASKET	Fig. A.
Check DRAIN FLANGE in BIDET to ensure that WHITE
FOAM GASKET (1) is fully compressed and not visible.
Fig. A.	DRAIN
POP-UP ROD ASSEMBLY	FLANGE
Insert LIFT ROD GUIDE (1) and CABLE CONNECTOR (2)
through rear hole, making sure SEAL WASHER (3) is
properly seated. Fig. B.	1 WHITE FOAM
	GASKET
From below slip slot in MOUNTING NUT (4) over CABLE (5).	NOT VISIBLE
Thread NUT (4) onto lift rod guide shank to secure ROD
GUIDE (1) to bidet. Hand tighten only. Fig. B.
	2

Fig. B. 1

3

SLOTTED

MOUNTING

NUT

4

ILLUSTRATION

SHOWN LESS2 VALVES

M 9 6 8 8 9 3