American Standard 2383.010, 4019.016 dimensions Features the Cadet 3 Flushing System

CADET® 3 ELONGATED 10"

ROUGH-IN TOILET

VITREOUS CHINA

CADET® 3 ELONGATED 10" ROUGH-IN TOILET

❑2383.010

•Vitreous china

•Low-consumption (6.0 Lpf/1.6 gpf)

•EverClean® surface inhibits the growth of stain- and odor-causing bacteria, mold, and mildew on the surface

•Features the Cadet® 3 Flushing System

•Elongated siphon action jetted bowl

•Fully-glazed 2-1/8" trapway with 2" ball pass

•Generous 9" x 8" water surface area

•Close-coupled tank with flat tank cover for superior storage

•Oversized 3" flush valve with chemical resistant flapper

•Chrome trip lever

•Speed Connect® tank-to-bowl coupling system

•Sanitary dam on bowl with four point tank stabilization

•2 color-matched bolt caps

•100% factory flush tested

• 5 year warranty	SEE REVERSE FOR ADDITIONAL ROUGHING-IN
	DIMENSIONS

❑3014.016 Elongated Bowl

❑4019.016 Tank

Nominal Dimensions:		To Be Specified:
		❏ Color: ❏ White ❏ Bone ❏ Silver ❏ Linen ❏ Black
724 x 432 x 737mm		❏ Seat: #5325.010 Elongated Champion® Slow Close
(28-1/2" x 17" x 29")		solid plastic seat and cover with easy lift off feature
		❏ Seat: #5284.016 Elongated EverClean® solid plastic
Fixture only, seat and supply by others		seat and cover
		❏ Seat: #5321.110 EverClean® Elongated Seat with
Alternative Tank Configurations Available:		Slow Close Snap-Off Hinges
❑ 4019.600 Tank complete with tank cover		❏ Supply with stop:
locking device
❑ 4019.800 Tank complete with trip lever
on right side
❑ 4019.900 Tank complete with tank cover
locking device and trip lever on right side
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.2M for Vitreous China Fixtures -	NOTES:
includes Flush Performance, Ball Pass Diameter,
	THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF
Trap Seal Depth and all Dimensions	254MM (10") FROM FINISHED WALL TO C/L OF OUTLET.
	SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED
• Los Angeles Department of Water and Power
	SEPARATELY.
Supplementary Purchase Specification for	* DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.
	IMPORTANT: Dimensions of fixtures are nominal and may vary within the range
Non-Adjustability
	of tolerances established by ANSI Standard A112.19.2.
	These measurements are subject to change or cancellation. No responsibility is
	assumed for use of superseded or voided pages.
		K63
© 2008 AS America Inc.			Revised 2/08