American Standard 4504S Install POP-UP Drain, Install Black Gasket, Install Gray Locknut

2 INSTALL POP-UP DRAIN

Remove CLEAR PLASTIC COVER (1). Remove CARDBOARD SPACER (2) from under DRAIN POP-UP (3). Fig. A.

Drop DRAIN BODY (4) through sink drain hole. Make sure WHITE FOAM GASKET (5) is under flange of DRAIN BODY (4). Fig. B.

Note: No plumber’s putty or caulk is required.

The CABLE ATTACHMENT POINT (6) must face towards the rear of the SINK. Fig. B.

Fig. A.

1

3

2

Fig. B.

REAR OF

SINK

4

5 6

SINK

DRAIN

HOLE

3 INSTALL BLACK GASKET

Install BLACK CONE GASKET (1) onto DRAIN BODY (2) from below.

Note: The flat side of the BLACK CONE GASKET (1) must face down.

2

1

FLAT SIDE OF GASKET MUST FACE DOWN

4 INSTALL GRAY LOCKNUT

Install GRAY LOCKNUT (1) onto DRAIN BODY (2) from below SINK. Fig. A.

Note: The flat side of the GRAY LOCKNUT (1) must face up.

Tighten firmly by hand. No tools are required. Check DRAIN FLANGE in SINK to ensure that WHITE FOAM GASKET (3) is fully compressed and not visible. Fig. B.

Fig. A.

2

FLAT SIDE OF

GRAY LOCKNUT

MUST FACE UP

1

Fig. B.

DRAIN

FLANGE

3 WHITE FOAM

GASKET

NOT VISIBLE

5 POP-UP KNOB

POP-UP KNOB (1) must be fully down.

DOWN

1

M968806 REV 1 . 3

2