features and specifications
LED level display these rows of LEDs display the Preamp Output Levels. Left and right channels are displayed independently at peak levels.
power indicator LED this LED is illuminated when the unit is properly powered, grounded and the remote power has been turned on.
fader control • in a 2 Amplifier, 4 Speaker system, rotating the knob to the FRONT side increases the level of the front speakers; rotating to the REAR side increase level of the rear speakers. At mid position, both sets of speakers are at maximum level.
•in a 2 Speaker system, the fader control should be rotated to the position which provides highest levels for both sets of speakers.
volume control allows adjustment of sound level for particular program material or source.
equalizer control this
subwoofer frequency control lets you adjust the subwoofer frequency and crossover point from
power connections connect to power source as follows:
+12V: Connect a red wire of at least 12 gauge to the car battery or other power source.
GROUND: Connect a black wire of at least 12 gauge to car chassis for ground connection
REMOTE: Connect an orange wire to remote activating (12V DC) wire of car stereo or other head unit.
subwoofer channel outputs RCA cables are used to connect the sub outputs to the subwoofer amplifier inputs. front channel inputs RCA cables are used to connect the front input signal from head unit or other source.
| PLE755S |
|
|
| |
| with Subwoofer Crossover and Bass Boost |
|
center frequencies | 65 Hz · 150 Hz |
|
| 400 Hz · 1.4 KHz |
|
| 2.4 KHz · 6 KHz |
|
| 15 KHz |
|
subwoofer crossover | 40 - 400 Hz |
|
bass boost | 0 - +18 dB |
|
frequency response | 20 - 20 KHz (+/– 1 dB) |
|
input level | 400 mV | 7 |
(for 400mV output) |
| |
total harmonic distortion (THD) |
| |
< 0.03% |
| |
(at 400mV output) |
|
|
output impedance | 10K Ohms |
|
90 dB |
| |
separation | 50 dB |
|
current drain | 450 mA |
|
power supply voltage | 12V DC Neg. Ground |
|
dimensions (W x H x L)
mm160 x 29 x 117
inches | 6.3 x 1.1 x 4.6 |