Stovax 5 manual Control Upgrade, Safety Precautions, Installation of the Stove, AR0934

Page 10

INSTALLATION INSTRUCTIONS

INSTALLATION

IMPORTANT: ENSURE THAT THE APPLIANCE IS CORRECTLY ADJUSTED FOR THE GAS TYPE AND CATEGORY APPLICABLE IN THE COUNTRY OF USE. REFER TO DATABADGE AND TECHNICAL SPECIFICATIONS AT THE FRONT OF THIS BOOKLET.

FOR DETAILS OF CHANGING BETWEEN GAS TYPES REFER TO SECTION 11 PAGE 20.

1.CONTROL UPGRADE

1.1This stove is fitted with a control valve that can be easily upgraded to battery powered remote control. There are two versions of this control which can be obtained through your local Gazco stockist.

1.2This upgrade can be fitted before or after installation but if side clearances are limited then it will be easier to upgrade the stove before installation. Full instructions are included with the kit.

1.3STANDARD REMOTE CONTROL This remote control can control the gas appliance after the pilot has been lit. It can turn the main burner on and regulate it from low through to high and back again. It can turn the main burner off leaving the pilot burning. GAZCO PART NUMBER 8455.

1.4THERMOSTATIC AND TIMER REMOTE CONTROL This remote control can control the gas appliance after the pilot has been lit. In ‘MANUAL MODE’ it can be used to turn the main burner on and manually regulate it from low through to high and back again. It can also be used to turn the main burner off leaving the pilot burning. In ‘AUTO MODE’ it will automatically regulate the room temperature. In ‘TIMER MODE’ it will turn the fire on and off according to a pre-set programme and automatically regulate the room temperature during two on periods. GAZCO PART NUMBER 8456

2.SAFETY PRECAUTIONS

2.1This appliance must be installed in accordance with the rules in force, and used only in a sufficiently ventilated space. Place read these instructions before installation and use of this appliance.

2.2All the instructions must be left intact with the user.

2.3In your own interest, and those of safety, this appliance must be installed by a competent person in accordance with local and national codes of practice. Failure to install the appliance correctly could lead to prosecution.

2.4This appliance is intended for use on a governed gas installation and set to the required pressure.

2.5Keep all plastic bags away from young children.

2.6Do not place any object on or near to the stove. Allow adequate clearance above the stove. See diagram 2 page 9.

2.7The stove is fitted with the Gazco Flue Sure System, which will act to cut off the gas supply to the appliance in the event of incorrect operation of the flue. If the system acts to shut off the gas supply, this indicates that there is insufficient flue pull. If this occurs a minimum of 10 minutes

should be allowed before trying to relight. Continued operation of this safety device means that there may be a serious problem with the flue system; a qualified gas engineer should inspect this. DO NOT USE THE STOVE

UNTIL AN ENGINEER SAYS IT IS SAFE TO DO SO.

2.8The Flue Sure System must not be tampered with. Use only genuine Gazco replacement parts when servicing the system - refer to servicing section on page 19.

3.INSTALLATION OF THE STOVE

3.1Open the carton, remove the accessory carton and stove unit. It will now be necessary to decide upon top or rear flue exit. The stove is factory built for rear flue exit but it may be changed to top exit by simply interchanging the flue spigot and blanking plate located on the stove.

3.2Position the stove ensuring all appropriate clearances are observed. Using a pencil, mark the position of the holes in the fixing brackets attached to the inside of the rear legs.

3.3Remove the stove and drill the holes using a number 12 masonry drill. Push rawlplugs into the holes and insert the woodscrews until the head is approximately 3mm proud of the hearth. Place the stove in position so that the screw heads located in the large part of the slot in the bracket, push the stove back so that the screw heads engage fully into the narrow part of the slot, tighten the screws if desired.

3.4Having run the gas supply to the stove, PURGE THE SUPPLY PIPE, this is essential to expel any debris that may block the gas controls. Connect the gas supply to the 8mm- compression elbow at the RH rear corner of the stove. There is a cutout in the RH rear leg to enable a direct straight connection to be made to the rear of the stove. See diagram 3. A gas soundness check must be completed up to the gas inlet connection.

3

AR0934

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Stockton Contents Flue Check Pass Fail Appliance Commissioning ChecklistGAS Check Lighting the Appliance User InstructionsGeneral 150 225Upgrading Your Stove Cleaning the FireTurning the Stove OFF AR1439Fuel BED Arrangement Flame Failure Device Installation DetailsGazco Flue Sure System RunningAR1451 Installation InstructionsTechnical Specification NOXFlue and Chimney Requirements Installation of the GAS SupplySite Requirements Appliance LocationSafety Precautions InstallationControl Upgrade Installation of the StoveAR0361 Fuelbed ArrangementAR0360 AR0363 Lighting AR1440Commissioning CommissioningServicing Requirements Servicing / Fault Finding ChartsServicing Instructions 5mmIgnition Functional Check Flame Failure Functional CheckMain Burner Replacing PartsPilot Unit AR1445 Ignition LeadPiezo AR0915 AR0916GAS Valve Magnetic Safety ValveAR0915 AR1452 Main InjectorAR1446 AR1442 AR1447 AR1448Primary Aeration Plate Changing Between GAS TypesControl Upgarde Short Spares ListService Records Member of the Stovax Group

5 specifications

Stovax 5 is a modern wood burning stove that has captured the attention of homeowners seeking both efficiency and style. Renowned for its innovative features, this stove is designed to deliver exceptional performance while adding a contemporary aesthetic to any living space.

One of the standout characteristics of the Stovax 5 is its clean burn technology. This system maximizes combustion efficiency, ensuring that more heat is generated from less fuel. As a result, the stove not only minimizes smoke emissions but also maximizes the extraction of heat from the wood, providing a longer burn time and greater warmth.

The Stovax 5 is built with a robust construction, featuring high-quality steel and cast iron components. This durability ensures longevity, making it a worthwhile investment for any home. Additionally, the stove’s body retains heat effectively, allowing it to continue radiating warmth long after the fire has died down.

A key feature of the Stovax 5 is its adjustable air controls. These controls provide users with the ability to fine-tune the airflow, achieving optimum combustion for both efficiency and user convenience. By regulating the air intake, homeowners can easily manage the fire's intensity and duration, ensuring that they enjoy a cozy atmosphere without excessive heat loss.

Aesthetically, the Stovax 5 boasts a sleek, modern design that complements various interior styles. Available in a range of finishes and sizes, it can fit seamlessly into both traditional and contemporary homes. The stove features large glass doors that provide a stunning view of the flames, enhancing the ambiance of any room and serving as a captivating focal point.

Furthermore, the Stovax 5 is equipped with an integrated flue system that simplifies installation. Its flexible flue options allow for various configurations, ensuring that it can be adapted to different chimney setups with ease.

Safety is another priority with the Stovax 5. The stove is designed with heat-resistant materials to prevent overheating, and it includes a secure door latch to minimize the risk of accidental openings.

In summary, the Stovax 5 combines advanced technology with stylish design, making it an excellent choice for anyone looking to enhance their home heating solutions. With its efficient burning system, durable construction, user-friendly controls, and aesthetic appeal, the Stovax 5 stands out as a leader in the wood burning stove market.
Top Page Image Contents