INSTALLATION
Removing the unit
1
Open/Close
2
3
4
1.Before removing the frame, press the OPEN/CLOSE button to slide down the front panel.
2.Frame
3.Insert fingers into the groove in the right side of the frame and pull out to remove the frame. (You can also remove the frame from the left side.)
4.Lever
After removing the frame, press the OPEN/CLOSE button again to slide up the front panel. Then insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers makes it possible to remove the unit from the dashboard.
DIN REAR-MOUNT (Method B)
Installation using the screw holes on the sides of the unit.
1
2
4
2 3
Fastening the unit to the factory radio mounting bracket.
1.Select a position where the screw holes of the bracket and the screw holes of the main unit become aligned (are fitted), and tighten the screws at 2 places on each side.
Use either truss screws (5 x 5mm), depending on the shape of the screw holes in the bracket.
2.Screw
3.Factory radio mounting bracket
4.Dashboard or Console
Note: The mounting box, outer trim ring, and
4