Marmitek 1082002 Talk Button, CAMERA-1,2,3,4 Buttons, Programmable Auto Sequence, Microphone

actual picture as displayed on the monitor.

2) To review the recorded pictures, press the VCR button on the monitor and then the PLAY button on the VCR.

7. TALK BUTTON

Press and hold this button to talk through the loud speaker built into the camera and release it to receive audio from the camera’s microphone.

8. CAMERA-1,2,3,4 BUTTONS

Press the corresponding button on the monitor for the desired camera channel.

9. PROGRAMMABLE AUTO SEQUENCE

Turns on/off the Auto Sequence Mode. In auto mode the system will switch between preset camera channels at a time sequence set by the dwell time adjuster. The sequencer is also programmable. Press and hold the auto button for 3 seconds, this will enable sequence memory mode and cause the auto LED to flash. With the auto led flashing press the channel of each camera required to be included in the display sequence (in the order that you wish them to be displayed).

When your selections are finished press the auto button in order to lock the memory.

IMPORTANT-This operation must be carried out when using less than 4 cameras in order to avoid switching to a blank screen. NB: The memory will be lost if the power to the monitor is lost.

10.POWER CONTROL BUTTON Press to turn on the power.

The screen will display the areas being monitored. Press again to turn power OFF.

11.MICROPHONE

Pick up your voice and sounds near the monitor. As soon as the TALK button is activated, your voice will be heard through the loudspeaker of the active camera (intercom function).

12. LED INDICATORS

LED POWER, AUTO, TALK, CAMERA 1~4 function indicators.

4 MARMITEK