Using Your Low Profile Fan Heater

Before First Use

Remove any promotional material and packaging from the heater.

Unwind the cord to its full length and place the heater on a firm, level surface in a stable, upright position. Visually inspect the air inlet and outlets to ensure there are no blockages.

Turning Your Heater On

Ensure the Heat Setting dial is turned to the OFF position and Variable Thermostat dial to “MAX”.

Plug the cord into a 230V or 240V power point and switch on.

NOTE: To avoid an electrical circuit overload, it is recommended that no other appliances are plugged into the same circuit as your heater, when it is in use.

The Power-On Indicator, on the front of the heater, will illuminate when the heater is turned on.

Setting the Heating Mode and Variable Temperature

To control the heater, turn the Heat Setting dial and Variable Thermostat dial as follows.

The Heat Setting dial has 4 modes: OFF - Shuts off the heater and fan

FAN - For fan only operation 1 - Low heat setting (1200 watts)

2 - High heat setting (2400 watts)

The Variable Thermostat dial acts as an automatic thermostat and can be used to maintain your desired temperature.

Turn the Heat Setting dial to setting

2 and the Variable Temperature dial to MAX setting. Once a comfortable room temperature has been reached, slowly turn the Variable Temperature dial anti-clockwise until a click sound is heard.

At this setting your heater will automatically cycle on and off to maintain the desired room temperature

Turn the heater off by turning the Heat Setting dial to the OFF position.

KFH520_IB_FA.indd 8

12/10/09 9:40 AM