Using Your Kambrook Jaguar Vacuum Cleaner
Remove all packaging from the unit, hose and other accessories; ensure that you have removed all of the accessories before discarding the packaging.
Ensure that the dust bag and filters are correctly fitted.
Locate the crush proof hose and push the connection point into the hose inlet connection on the top of the unit, until a “click” sound is heard.
Connect the wide end of the metal wand to the hose end, and push together firmly.
Fit the floor tool to the narrow end of the wand/s and push together firmly.
Fully extend the power cord by pulling the power plug (situated at the rear of the unit) out from the unit, until the red/yellow tape on the cord is shown.
ENSURE THAT YOU DO NOT OVER EXTEND THE POWER CORD – DO NOT EXTEND PAST THE RED/YELLOW WARNING TAPE ON THE CORD
Plug into a 230/240v power point and switch the power on.
To commence vacuuming push down on the on/off foot pedal, at the top, rear of the unit. 
When vacuuming is complete, push down on the ‘on/off’ pedal to switch off.Turn the power off at the outlet and then remove the power cord from the power outlet (when removing plug from the power outlet grasp the plug not the cord).
To retract the cord push down on the ‘cord rewind’ pedal. 
IMPORTANT: HOLD THE PLUG END WHEN RETRACTING THE CORD TO PREVENT IT FROM STRIKING YOU OR THE VACUUM.
ALWAYS ENSURE THAT THE DUST BAG AND THE MOTOR PROTECTION FILTER ARE CORRECTLY FITTED. NEVER OPERATE WITHOUT THE DUST BAG OR FILTERS IN PLACE.
Crevice and brush tool accessories
The crevice tool is ideal for vacuuming hard to reach places such as the edges along skirting boards, crevices, corners and in between cushions.
The brush tool can be used to vacuum delicate surfaces and areas such as shelves venetian blinds, furniture & lampshades.
Separate crevice and brush tools are located inside the
Turn off the vacuum cleaner when changing any attachments.
Dust bag indicator and changing the dust bag
The dust bag should be emptied when full. The dust bag indicator window will gradually turn red as the bag fills up and when the dust bag indicator displays ‘red’ it is time to change the dust bag.
Always switch appliance off, then switch off at the power outlet and unplug the appliance prior to replacing dust bags or filters.
To remove the dust bag, ensure the unit is down on its wheels, remove the crush proof hose and push the ‘Dust bag compartment lid release lever’ Once the lid has released, pull the top cover back.
To remove the bag, grasp the plastic insert attached to the dust bag and pull upwards as per arrow indicator.
To empty the bag, remove the plastic bar attachment at the bottom of the bag by sliding across. Once the bag has been emptied, replace the sliding bar and your bag is ready to
Filter holder
Dust bag holder
When vacuuming fine dust particles, the fine dust particles can clog the pores of the dust bag and the dust bag indicator will indicate full. If this happens the bag could appear relatively empty, however the bag will still need to be emptied to avoid strain on the motor.
NOTE:The bag compartment lid may not close if
the bag is not correctly fitted.
IMPORTANT: DO NOT USE THE UNIT WITHOUT A DUST BAG IN PLACE
Replacing filters
Filters must be cleaned from time to time to remove the fine dust particles that have been collected.This can be done by shaking them, however after approximately 8 dustbag changes the filters should be replaced.
Motor protection filter
The motor protection filter must always be in place when operating the vacuum otherwise damage to the motor may occur
To replace the motor protection filter – Remove the dustbag or pull the bag forward.The motor protection filter is located at the rear, right hand side of this inner chamber. Pull the plastic filter holder upward to remove.
Filter holder
Removable filter
4 | 5 |