LOREX Technology L19lD1616501 instruction manual Interval setup, Alarm setup, Event Popup Setup

Configuration

When the window is at the ALL OFF mode, you can activate the motion detection in the block.

5.BLOCK OFF: Block an area to deactivate the motion detection in the desired area. The setup steps are the same as BLOCK ON. If the window is at the ALL ON mode, you can deactivate the motion detection in the block you make.

Interval setup

SWITCH INTERVAL: FULL- Full Screen

Sequence Interval setup. (Range: 1~99 SEC)

PIP- Picture in Picture, the sub-picture's sequence interval setup. (Range: 1~99 SEC)

2.[EVENT RECORD]

The Event Update Time prevents the DVR from recording the event logs from the same event. The event types include alarm, motion and video loss.

When an event is triggered, it is possible that the same event will continue to be triggered for a period of time. With the help of Event Update Time, whenever there is an event, the DVR records the starting time and information of the event in the Event Log, and ignores the following events within the duration set in the Event update time. The setting range of the Event Update time is from 10 seconds to 990 seconds.

Alarm setup

1.CHANNEL - Use [+] and [-] to select a channel.

2.ALARM INPUT- Set up the Alarm Input type.

•N.C- when the alarm is triggered, the circuit turns closed (ON).

•N.O- when the alarm is triggered, the circuit turns opened (OFF).

3.DURATION - Set up a post- alarm recording duration and the alarm output duration. The duration setting is applied to both functions. The setting range is from 1 second to 300 seconds.

NOTE: Alarm output can be triggered by alarm input. Motion and video loss cannot trigger an alarm output.

Event Popup Setup

36