Jabra 2400 user manual Wearing the Headset with an Ear Hook, How to remove the headband

5 6

5.How to remove the headband

Remove the ear cushion by gently pulling it off the ear-plate. Push on the inner part with your thumb until the headset clicks out of the headband.

6.How to press the headset into the headband ring on the headband.

Hold the headband in one hand and the headset in the other. Align the headset against the outside of the headband ring with the headset cable pointing down. Gently press the headset into the headband ring until it clicks into place.

Wearing the Headset with an Ear Hook

Two sizes of ear hook are included with some Jabra BIZ 2400 models. They can be purchased as an accessory for any mono model. To use it:

L R

1 2 3

1.How to attach the ear gel.

The ear gel is a round rubber part which helps stabilize the headset on your ear. Place the ear gel inside the ear hook ring. Gently push the ear gel through the hole so that it sits in the hole. Once you click the headset into the ear hook ring, the ear gel will be locked into place.

2.How to press the headset into its ear hook ring on the ear hook.

Hold the ear hook ring in one hand and the headset in the other. On the inside surface of the ear hook ring you will find "L" and "R" markings. Align the cable of the headset with the "R" marking if you wish to wear it on you right ear, or "L" if you wish to wear it on your left ear. Gently press the headset into the ear hook ring until it clicks into place.

5