Hunter Fan 41968-01, Type 8 Wiring the Fan, Dual Switch Wiring, Single Switch Wiring

Page 7

4 • Wiring the Fan

fsdfsdf

All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician.

Wall switches are not included. Select an acceptable general-use switch in accordance with national and local electrical codes.

4-1. Before attempting installation, make sure the power is still off.

4-2. To connect the wires, hold the bare metal leads together and place a wire connector over them, then twist clockwise until tight. For all these connections use the wire connectors provided.

4-3. Connect the bare or green ground wire (grounded) from the ceiling to the green ground wire (grounded) from the ceiling plate and the green ground wire from the fan.

4-4. Connect the white wire (ungrounded) from the ceiling to the white wire (ungrounded) from the fan.

4-5. Connect the remaining wires as follows:

Dual Switch Wiring:

The black wire (ungrounded) from the ceiling to the black wire (ungrounded) from the fan

The black/white wire (ungrounded) from the fan to the wire (ungrounded) for the wall switch

Single Switch Wiring:

The black wire (ungrounded) from the ceiling to the black (ungrounded) and the black/white wire (ungrounded) from the fan

CAUTION: Be sure no bare wire or wire strands are visible after making connections.

4-6. Turn the splices upward and push them carefully back through the ceiling plate into the outlet box.

4-7. Spread the wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box.

7

Wire

Connector

Dual Switch Wiring

Single Switch Wiring

41968-01 • 10/02/08 • Hunter Fan Company

Image 7
Contents Type 8 Models Operating your fan Located on the top of the fan motor housingUse only Hunter replacement parts Disconnect the power by turning off the circuit breakers toInstaller’s Choice and Optional Accessories Getting Ready Installing Multiple Fans?Installing the Ceiling Plate For Low Profile mounting Unbundle the wires from the fanAssembling and Hanging the Fan For Standard or Angled mountingDual Switch Wiring Wiring the FanSingle Switch Wiring Installing the Canopy and Canopy Trim Ring Assembling the Blades Installing the Switch Housing Installing the Light Fixture Turn on electrical power to the fan Operating and Cleaning Your Ceiling FanProblem Excessive wobbling TroubleshootingProblem Nothing happens fan does not move Problem Noisy operation