Hunter Fan 41675-01 Install Globe, Operation of Remote Control, Mounting the Remote Holder

Page 6

Step 10: Install Globe

A.Install the included bulb connecting the plug from the light fixture to the bulb. Refer to Figure 10.

Figure 10

B.Carefully lift the glass shade up inside of the light fixture as far as it will go. Rotate the shade in a clockwise direction until it is held tightly in place by the three tabs.

Step 11: Operation of Remote Control

The hand-held transmitter has individual buttons for control of the light, for controlling the fan speeds, for turning the fan off, and for reversing. See Figure 11.

Pressing the “LIGHT” button will turn the light on to full bright- ness. Holding the button will cause the light to dim slowly— release the button at the desired brightness to hold the selected brightness level. Pushing the button again will turn the light off.

The fan may be started by pressing the HIGH, MEDIUM, or LOW speed buttons. For best operation, allow the fan to start on HIGH, then select the desired speed. Press the fan OFF button to turn the ceiling fan off. Press the REVERSE button to change the fan’s direction while the fan is running.

NOTE: Replace 12-volt battery with type 23 A, MN-21 or equivalent.

Reverse

Fan High

Fan Medium

Fan Low

Fan OFF

Light Key

Figure 11

Step 12: Mounting the Remote Holder

A holder is supplied with the transmitter which can be mounted to a existing toggle switch wall plate. The holder will help pre- vent misplacement of your transmitter by providing a permanent receptacle. See Figure 12.

If desired, the holder can be mounted to a convenient location on a wall.

Figure 12

41675-01 01/07/2004

6

© 2004 Hunter Fan Company™

Image 6
Contents Read and Save These Instructions Pre-Installation InstructionsInstallation of Outlet Box and Rough-In Wiring Inspection of FanInstallation of Ceiling Plate Installer’s Choice Hanging SystemFan Assembly Low Profile Version Install Remote Control Final WiringBall Hanging Version Finish Hanging Fan Fan Blade Assembly Installation, and Balancing Install Globe Operation of Remote ControlMounting the Remote Holder Troubleshooting Guide Problem Probable Cause Solution41675-01 01/07/2004