5 • Setting the Remote Transmitter and Receiver
You must now set the jumpers in the remote transmitter and DIP switches in the receiver so that
Example DIP Switch Settings
they match.
Setting DIP switches and Jumpers
When two or more fans are located near each other, you may desire to have the receiver/transmitter for each fan set to a different code, so that the operation of one fan does not affect the operation of the other fans.
Receiver 2
DIP Switches
Set to 0111
Transmitter 1
Receiver 2
DIP Switches
Set to 0100
Transmitter 2
The DIP switches for the receiver are located on the flat surface of the receiver. The Jumpers for the transmitter are in the the battery compartment.
DIP Switches | DIP Switches |
Set to 0111 | Set to 0100 |
Receiver DIP switches
Example Jumpers Settings
in the transmitter matches the position of the DIP switches in the receiver. If they don’t match, the controller will not function. For instructions on how to set the jumpers, read the box below.
CAUTION: The remote control device complies with part 15 of the FCC rules. Changes or modifications not expressly approved by Hunter Fan Company could void your authority to operate this equipment.
Operation is subject to the following two conditions:
1.This device may not cause harmful interference.
2.This device must accept any interference received, including interference that may cause undesired operation.
Note: Use with a fan that incorporates an air gap switch (normal on- off wall switch).
WARNING: Maximum fan load is 1 Amp; maximum lamp is 100 Watts. Do not use any speed control with this product.
10
Receiver 1
4 3 2 1
Transmitter 1
4 3 2 1
4 = off (apagado)
3 = on (encendido)
2 = on (encendido)
1 = on (encendido)
Receiver 2
4 3 2 1
Transmitter 2
4 3 2 1
4 = off (apagado)
3 = on (encendido)
2 = off (apagado)
1 = on (encendido)
Remote
Transmitter
Jumper Switches