Hunter Fan 42775-01 For Low Profile mounting, Optional Downrod Instructions, Go back to Step

3 • Assembling and Hanging the Fan

For Low Profile mounting:

Note: For low profile mounting, the downrod is replaced with the low profile washer.

3-5. Remove the set screw from the adapter.

3-6. Place the low profile washer (lip up) into the canopy. Be sure the green ground wire is pointing up toward the ceiling.

3-7. Align the holes in the washer with the holes in the adapter. Assemble securely with three low profile screws.

3-8. Raise the fan and place the hook on the ceiling plate through the U-shaped hole in the rim.

Optional Downrod Instructions:

Your Hunter fan comes with an optional downrod extension pipe. If you would like to use the enclosed optional 6 inch downrod, follow the steps below.

Note: The Perfect BalanceTM system is designed for downrods that are 6” and shorter. If you use a downrod longer than 6 inches, do not remove the red retaining screws.

3-9. Remove the pipe ball screw from the standard downrod, then slide the ball off the pipe.

3-10.Remove the pin from the pipe, then slide the wedge off the pipe.

3-11. Remove the screw and ground wire from the pipe.

3-12.Reassemble the ground wire, wedge, pin, ball, and pipe ball screw, in that order, onto the long downrod.

3-13.Go back to Step 3-2.

Low Profile Screw

Steps 3-5 – 3-6

Low Profile Washer

Step 3-7

U-shaped

Hole

Steps 3-9 – 3-12 Pipe Ball Screw

Ground Wire

and Screw

Pin

Ball

Wedge

7

42775-01 • 04/29/08 • Hunter Fan Company