Hunter Fan 41931-01 warranty Wiring the Fan

All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician.

Wall switches are not included. Select an acceptable general-use switch in accordance with national and local electrical codes.

4-1. Disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location.

4-2. Decide how you want to set up the fan and light controls. You can control the fan and/or lights together or separately using one or two wall switches. Follow Step 4-3 OR Step 4-4, depending on what you decide.

Note: If you are not installing a light kit, follow step 4-4.

4-3. If you want to, you can control the fan and light separately using two wall switches, connect the wires as follows: connect the green ground wire to the ground wire, connect white wire to white wire, connect black wire to black wire, and connect the black/white wire from the fan to the wire for the wall switch.

4-4. Alternatively, you can control both fan and light with one switch. To do so connect the wires as follows: connect the green ground wire to the ground wire, connect white wire to white wire, connect the black and the black/white wire from the fan to the black wire in the ceiling.

4-5. To connect the wires, hold the bare metal leads together and place a wire nut over them, then twist clockwise until tight.

CAUTION: Be sure no bare wire or wire strands are visible after making connections.

4-6. Push all wires and wire nuts back through the ceiling plate hole into the outlet box.

Wire Nut

4 • Wiring the Fan

Step 4-3



Step 4-4

41931-01 • 04/14/07 Hunter Fan Company