Installing the switch housing

attaching the upper switch housing

1.Partially install two #6-32 x 3/8" housing assembly screws into the switch housing mounting plate as shown in Figure 22.

2.Feed the upper plug connector through the center opening of the upper switch housing. See Figure 22.

Lower Plug

Connector

Housing

Assembly

Screw

Upper Switch

Housing

Upper Plug

Connector

Lower

Switch

Housing

Switch Housing	Housing
Switch Housing	Assembly
Mounting Plate	Screw

Upper Plug

Connector

Upper Switch

Housing

Figure 22 - Attaching the upper

switch housing to the mounting plate

3.Align the keyhole slots in the upper switch housing with the housing assembly screws installed previously.

4.Turn the upper switch housing counterclockwise until the housing assembly screws are firmly situated in the narrow end of the keyhole slots as shown in Figure 23. Install the one re- maining #6-32 x 3/8" housing assembly screw into the third hole in the upper switch housing. Tighten all three screws firmly.

Figure 23 - Mounting the upper switch housing

CAUTION: Make sure the upper switch housing is se- curely attached to the switch housing mounting plate. Fail- ure to properly attach and tighten all three housing assem- bly screws could result in the switch housing and light fix- ture falling.

attaching the lower switch housing

1.Connect the upper plug connector from the motor to the lower plug connector in the lower switch housing assembly. See Fig- ure 24.

NOTE: Both plug connectors are polarized and will only fit together one way. Make sure that both connectors are prop- erly aligned before connecting them together. Incorrect con- nection could cause improper operation and damage to the product.

41892-01 03/17/2005

Figure 24 - Connecting the plug connectors

2.Place the lower switch housing assembly over the upper switch housing. Align the side screw holes in the upper and lower switch housings. Attach the lower switch housing to the up- per switch housing with three #6-32 x 3/8" housing assembly screws. See Figure 24.

installing the glass shades and bulbs

Refer to Figures 25 and 26.

1.Place globe over threaded lampholder in cup.

2.Install and hand tighten threaded locking ring on lampholder. NOTE: As shown in Figure 1b, line up the beginning of the first thread on the lamp holder and notch on the locking ring to avoid cross threading the ring. If ring becomes hard to turn, turn ring counter-clockwise to loosen. Do not force the ring on.

3.Install A-15 Max 60 Watt bulbs.

Cup

Threaded

Lamp Holder

Globe

Threaded

Locking Ring

Figure 25 - Multifixtures

Beginning of

First Thread

Threaded

Locking Ring

Notch in Ring

Figure 26 - Locking Ring Assembly

41892-01_Rev 03.17.05.pmd

3/18/05, 8:44 PM