7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
7-15. To uninstall the light fixture, first disconnect the plug connectors between the black wire and the black/white wire.
| 7-16. Disconnect the plug connectors between the two white | Lower Switch |
| Housing |
| wires. |
| |
7-17. Uninstall the connector and washer from the end of the light fixture inside the lower switch housing.
7-18. Unscrew the threaded rod of the light fixture from the lower switch housing.
7-19. Remove the light fixture from the lower switch housing pulling disconnected wires through the hole in the center of the lower switch housing.
| Note: When removing the wires, pull the thin plug | | | |
| connector (male) through first, and then pull the other | | | |
| plug connector (female) through the hole. | | | | | Threaded Rod |
7-20. Install the dummy terminals (included in the sack parts) | | |
| | |
| on the two disconnected wires in the lower switch | | | |
| housing. | | | | | |
7-21. Install the switch housing cap and plug button to the | | | |
| lower switch housing. | | | Steps 7-17 – 7-19 |
7-22. Once you have uninstalled the light fixture, continue | |
| | | |
| with step 7‑6. | | | | | |
| | | | | |
| | Male Dummy | | | | | | |
| | | | | | | |
| | | | | |
| | Terminal | | Cap | | | |
| | Female Dummy | | | | | | |
| | Terminal | | Plug Button | | | Step 7-21 |
| | | | | | | |
| | | | | | | | |
| | | | | | | | |
13
12345-01 • 12/06/07 • Hunter Fan Company