Grizzly G0638, G0637 owner manual

3.Apply the 10 x 50 x 2000mm gaskets to the underside of the collection drum lids (see Figure 34).

Figure 34. Applying dust collection drum lid

gasket.

4.Install the drum lid latches on the upper part of each collection drum assembly with (12) #10-24 x 3⁄8" Phillips head screws and (12) #10-24 hex nuts (see Figure 35).

Figure 35. Collection drum lid latch installed.

5.To prevent a vacuum leak in the collection drums, use (12) #10-24 x 3⁄8" Phillips head screws and (12) #10-24 hex nuts to plug the holes in the lower half of the collection drums.

G0637/G0638 Cyclone Dust Collector

6.Attach each set of four bag holder panels with the (24) #10-24 x 3⁄8" Phillips head screws and (24) #10-24 hex nuts to make two dust collection drum bag holders (see Figure 36).

Figure 36. Dust collection drum bag holder

assembled.

7.Attach two rubber handles to the inside of each bag holder assembly with (4) 1⁄4"-20 x 5⁄8" hex bolts, (8) 1⁄4" flat washers, and (4) 1⁄4"- 20 hex nuts.

8.Insert the 640 x 1200mm dust collection bags and bag holders into the drum collection assemblies, as shown in Figure 37.

Figure 37. Dust collection bag and bag holder

inserted into collection drum assembly.

-25-