Radio Shack XL-400 Connecting Four Speakers, Connecting Two Speakers Unbridged Connection

Page 13

12-2018.fm Page 13 Friday, May 12, 2000 12:46 PM

Connecting Four Speakers

CH1 Front

CH2 Front

CH3 Rear

CH4 Rear

Left Speaker

Right Speaker

Left Speaker

Right Speaker

1.Use a screwdriver to connect the front left speaker’s positive (+) wire to the amplifier’s CH1 (+) terminal.

2.Use a screwdriver to connect the front left speaker’s negative (–) wire to the amplifier’s CH1 (–)terminal.

3.Repeat Steps 1–2 to connect the front right speaker’s positive (+) and negative

(–)wires to the amplifier’s CH2 (+) and CH2 (–)terminals.

4.Repeat Steps 1–3 to connect the rear left and rear right speaker’s positive (+) and negative (–) wires to the amplifier’s

CH3 (+), CH3 (–) ,CH4 (+), and CH4 (–) ter- minals.

Connecting Two Speakers (Unbridged Connection)

Left Speaker

Right Speaker

This connection produces 100 watts per channel. Use this connection if you do not have high-power speakers.

1.Use a screwdriver to connect the left speaker’s positive (+) wire to the ampli- fier’s CH3 (+) terminal.

2.Use a screwdriver to connect the left speaker’s negative (–) wire to the ampli- fier’s CH3 (–)terminal.

3.Repeat Steps 1–2 to connect the right speaker’s positive (+) and negative (–) wires to the amplifier’s CH4 (+) and CH4

(–)terminals.

Connecting Inputs

13

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Image 13
Contents XL-400 High Power 2-Channel Bridgeable Amplifier Contents FCC Wants YOU to Know Features14K Gold-Plated Noise-Isolated Low-Lev Preparation Before YOU Begin the InstallationSupplied Hardware Choosing a Mounting LocationRouting Cables and Wires Installation OrderBefore YOU Make the Connections Preparing the Mounting AreaConnecting Ground and SWITCHED/PRIMARY Power Fm Page 7 Friday, May 12, 2000 1246 PM LOW-LEVEL Inputs Connecting InputsUsing either a floating or common ground connection HIGH-LEVEL Speaker Wire InputsFloating Ground Connection Four Speaker OutputsCommon Ground Connection Two Speaker Outputs Preparing the Speaker Wires Connecting SpeakersConnecting Two Speakers Unbridged Connection Connecting Four SpeakersConnecting Two Speakers Bridged Connection Connecting Two Unbridged Speakers and One Bridged Subwoofer Testing Connections Completing the InstallationCle’s negative battery terminal. Then Mounting the AmplifierCompleting the Installation Operation Adjusting the Audio LevelTurning on Amplifier Adjusting Frequency Crossover Symptom Possible Cause Suggestion TroubleshootingReplacing a Fuse CareReplacing the SFE-Type Fuse Replacing the Blade-Type FusesFm Page 22 Friday, May 12, 2000 1246 PM Specifications Limited One-Year Warranty