Samsung RN15LSBAN/EDC manual Connecting Your FPD Monitor, Or graphics card, Successfully installed

Page 7

Setting up Your Monitor

Connecting Your FPD Monitor

➂ ➄

②

➃

➃

Figure 3. Cable connections

1

Turn off your computer and unplug its power cord.

2

Connect the signal cable to the 15-pin, D-sub connector on the back of your monitor.

3

Connect the signal cable to the video port on your computer, video board, video card,

or graphics card.

4

Connect the power cord for your monitor to the DC adapter and connect the adapter

jack to the DC power port on the back of your monitor.

5

Plug the computer and monitor power cords into a nearby power mains outlet.

6

Turn your computer and monitor on. If your monitor displays an image, it has been

successfully installed.

7

If necessary, install the video driver for this monitor (see “Installing the Video Driver”

on page 7).

8

After your monitor has been fully installed, run Auto Adjustment (see page 11).

English

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents
SyncMaster 570S TFT 580S TFT Flat Panel Monitor Page Table of Contents Safety Instructions English Unpacking Your MonitorSetting up an Ergonomic Workstation Setting up Your MonitorKensington Security Slot Or graphics card Connecting Your FPD MonitorJack to the DC power port on the back of your monitor Successfully installedAudio in jack Connecting Your Multimedia FPD MonitorMIC OUT jack CardPlug and Play Installing the Video DriverWindows PROPERTIES, Monitor tab, have Disk Self-Test Feature Check StfcVersion 4.00.950A Version 4.00.950BWarm-up Time Getting HelpMonitor User Controls Adjusting Your FPDAuto Adjustment Direct-Access FeaturesAutomatic Save OSM Lock/Unlock Function icons Function name Setting slidebarOn-Screen Menu System OSM BrightnessOSM functions and adjustments Accessing the menu systemBrightness Contrast Position Image LockColor Control ResetTemperature ColorTime LanguageMenu Position Menu DisplayDisplay Mode This screen shows the horizontal and vertical Microphone On/Off Turns the sound on and off VolumeAudio Controls InternalAppendix PowerSaverTroubleshooting Move the computer’s mouse or Screen is blank Monitor is using its power PowerSaverDisplay Mode Management systemCheck the volume control on Documentation Troubleshooting problems AudioConnecting your Raise the volume Sound level isYour computer or sound Specifications DDC Data Horizontal Sync Not used Vertical Sync Pin D-sub connectorPin Assignments Red Green Green + H/V Sync BlueDisplay Modes Preset timing modesScreen Turn off your monitor and unplug its power cordChanging the Base Removing the baseRear cover Maintenance of Your Flat Panel DisplayUnplug the monitor from the power outlet before cleaning Attaching a baseIndex Stfc 8V-position Tilt the screen MPR II Compliance Regulatory InformationFCC Information IC Compliance NoticeGermany
Related manuals
Manual 30 pages 23.92 Kb Manual 30 pages 21.3 Kb Manual 30 pages 5.71 Kb Manual 30 pages 22.88 Kb Manual 33 pages 38.16 Kb
Top Page Image Contents