Samsung LS19TWPSUV/CH T220P Check List, No images on the screen. I cannot turn on the monitor

Troubleshooting

{T220P} Check List

Note

Before calling for assistance, check the information in this section to see if you can remedy any problems yourself. If you do need assistance, please call the phone number on the In- formation section or contact your dealer.

No images on the screen. I cannot turn on the monitor.

Q:Is the power cord connected properly?

A:Check the power cord connection and supply.

Q:Can you see "Check Signal Cable" on the screen?

A:(Connected using the D-sub cable) Check the signal cable connection. (Connected using the DVI cable)

If you still see an error message on the screen when the monitor is connected properly, check to see if the monitor status is set to analog.

If you still see an (error) message on the screen when the monitor is connected properly, check to see if the monitor status is set to analog. Press ‘/SOURCE’ button to have the monitor double-check the input signal source.

Q:If the power is on, reboot the computer to see the initial screen (the login screen), which can be seen.

A:If the initial screen (the login screen) appears, boot the computer in the applicable mode (the safe mode for Windows ME/XP/2000) and then change the frequency of the video card.

(Refer to the Preset Timing Modes)

If the initial screen (the login screen) does not appear, contact the Service Center or your dealer.

Q:Can you see "Not Optimum Mode", "Recommended Mode 1920 x 1200 60 Hz" on the screen?

A:You can see this message when the signal from the video card exceeds the maximum resolution and frequency that the monitor can handle properly.

A:Adjust the maximum resolution and frequency that the monitor can handle properly.

A:If the display exceeds SXGA or 75 Hz, a "Not Optimum Mode", "Recommended Mode 1920 x 1200 60 Hz" message is displayed. If the display exceeds 85 Hz, the display will work properly but the "Not Optimum Mode", "Recommended Mode 1920 x 1200 60 Hz" message appears for one minute and then disappears.

Please change to the recommended mode during this one-minute period.

(The message is displayed again if the system is rebooted.)

Q:There is no image on the screen. Is the power indicator on the monitor blinking at 1 second intervals?

50