| INSTRUCTION SHEET NO. |
L~EDROP FIXTURE | IS:8626 |
!NSTRUCTIONSFOR INSTALLATIONOF |
|
FOR USE WITH 8600 SERIES POWER JACKS ONLY | 1189 |
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these Instructions for maintenance reference.
MOUNTING
1.If used with POINT POWER JACK #8605, use the cap marked “35W MAX’ If used with other POWER JACKS, make certain that the STEM BUSHING is removed from the POWER JACK ENTRY (Fig. 2).
2.Screw the JACK ASSEMBLY fully into the POWER JACK (Fig. 2).
INSTRUCTIONSFOR LAMPING
CAUTION: MAKECERTAINTHATTHELYTEDROP FIXTURE IS COOL BEFORE HANDLING. SINCE THE IAMP HENS QUICKLY, MAKE SURE THAT THE POWER IS DISCONNECTED BEFORE INSERTING LAMP INTO THE LAMP SOCK=.
1, SEPARATE
Lift the GLOBE ASSEMBLY (with STYLE JACK SHADE) while rotating to the LE~ until it is released from the LAMP SOCKET ASSEMBLY (Fig. 1).
2, lN~ALL LAMP
CAUTION: DO NOT TOUCH THE IAMP WITH BARE HANDS.
Oils from the hands could reduce L4MP life. Use tissue paper or a soft cloth. Insert the LAMP into the SOCKET holes as far as it will go. Pins will be exposed approximately h“ outside of the SOCKET when
fully enaaaed. No ~olarity. of Dins is required.
.-
3.REASSEMBLE (Fig. 2).
POWER JACK ENTRY ~35wMAx.cAp
NOTE: Lamp replacement:
LAMP SOCKET
/‘SSEMBLY
JACK ASSEMBLY
-/IIo69 OR
STEM BUSHING
REMOVED
I | I | LAMP (SEE NOTE) |
|
| GLOBE ASSEMBLY |
|
| / |
\
FIG. 1
STEM 1[
FIG.
NOTE: THE STEM HAS A
TO SEPARATE
CONCEALED FLEX TO ABSORB IMPACT.
TO REPLACE