Lightolier instruction sheet IS6273, McH Tcx1E 1? MONTREAL,QUEBECCANADA

Y

READAND UNDERSTAND THESE INSTRUCTIONS BEFOREINSTALLING FIXTURE

“his fixture is intended for installation in accordance with the National Electrical Code and local regulations. “oassure full compliance with local codes and regulations, check with your local electrical inspector before mtallation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

INSTRUCTION SHEET NO.

IS:6273

Retain these instructions for maintenance reference. 1094 Page 1 of 2

b

INSTRUCTIONS FOR ATTACHING SOF-TECH” LOW VOLTAGE TO LYTESPAN” TRACK

FOR USE WITH LYTESPANiTRACK SYSTEMS ONLY

INSTRUCTIONS FOR ATTACHING SOF-TECH” LOW VOLTAGE TO SINGLE CIRCUIT TRACK SYSTEM

1.Insert into LYTESPAN TRACK (see Fig. 1). LOCKING I-EVER must be in same side of track as BEAD.

2.Rotate FllllNG 90” clockwise (see Fig. 2).

3.Rotate FITTING until LOCKING LEVER snaps and locks in place (see Fig. 3).

4.To remove: depress LOCKING LEVER, then rotate FITTING 90” counterclockwise.

	~=_=&;_Q/-’’’’’’~~TRACK
	‘-%2
	r
BEAD	—
45	== — d

LOCKING1

LEVER

FIG.1FIG.2

INSTRUCTIONS FOR CONVERTING SOF-TECH@ LOW VOLTAGE

ATTACHMENT FITTING TO OPERATE ON 2 CIRCUIT TRACK

(See Fig. 4) BRASS CONTACT can be raised or lowered. Broken line indicates position for 1 circuit track system or lower circuit of 2 circuit track system.

~}1		.,	Fi
Ii-.	—_—.4–:=,’:,
~;~p,,			~
\, ,:\yil	.;.	-~

“i---:-+‘“- ~ 1.,

1-””

\,,,—-.

.-’

J

TO

REMOVE

[! .,,

FIG.3

	BRASS CONTACT
	./>
	q-
	,,=LOCKING
*L	LEVER
(~’,	&:.;=s

G-

To convert attachment FITTING for upper circuit of. 2 circuit track, raised BRASS CONTACT to high position by lifting CONTACT as high as stop permits and CONTACT clicks into place.

[1

SEE BACK FOR LAMPING

w—-

FIG.4

@FALL RIVER, MASSACHUSETTS, 02720

Mc>H Tcx1E 1? MONTREAL,QUEBECCANADA

d