Samsung HT-D5200/XE, HT-D5200/XN Connecting the FM Antenna, Wireless LAN Adapter not supplied

Wireless Network

You can connect to the network with a Wireless IP sharer.

1.A wireless AP/IP router is required to make a wireless network connection. Connect the wireless LAN adapter to the Wireless LAN Adapter on the rear panel of the product.

02 Connections

2.Set the network options. (See page 33)

Broadband service

Wireless IP sharer

PC

Networking with PC for AllShare function (See page 64)

✎NOTE

LAN

		DIGITAL
iPod
	AUDIO IN
	OPTICAL

WIRELESS LAN

Wireless LAN Adapter (not supplied)

This product is compatible with only Samsung's Wireless LAN Adapter. (not supplied) (Model name: WIS09ABGN).

-The Samsung Wireless LAN Adapter is sold separately. Contact a Samsung Electronics retailer for purchasing.

You must use a wireless IP sharer that supports IEEE 802.11 a/b/g/n. (n is recommended for stable operation of the wireless network.)

Wireless LAN, by its nature, may cause interference, depending on the use condition (AP performance, distance, obstacles, interference by other radio devices, etc).

Set the wireless IP sharer to Infrastructure mode. Ad-hoc mode is not supported.

When applying the security key for the AP (wireless IP sharer), only the following is supported.

1)Authentication Mode : WEP, WPAPSK, WPA2PSK

2)Encryption Type : WEP, AES

For the AllShare function, a PC must be connected in the network as shown in the figure.

Connecting the FM Antenna

FM Antenna (supplied) 1. Connect the FM antenna supplied to the FM ANTENNA Jack.

2.Slowly move the antenna wire around until you find a location where reception is good, then

FM ANT fasten it to a wall or other rigid surface.

✎NOTE

 This product does not receive AM broadcasts.

English 23

HT-D5200_ELS_1226.indd 23 2011-12-26 ￿￿ 9:26:43