Connections
Wireless Network
You can connect to the network with a Wireless IP sharer.
1.A wireless AP/IP router is required to make a wireless network connection. Connect the wireless LAN adapter to the Wireless LAN Adapter on the rear panel of the product.
2.Set the network options. (See page 38)
Broadband service
Wireless IP sharer
PC
Networking with PC for AllShare function (See pages 61~62)
✎NOTE
LAN | COMPONENT OUT | |
HDMII OUTOUT |
|
|
WIRELE LAN | AUX IN | VIDEO OUT |
Wireless LAN Adapter (not included)
This product is compatible with only Samsung's Wireless LAN Adapter. (not supplied) (Model name: WIS09ABGN).
-The Samsung Wireless LAN Adapter is sold separately. Contact a Samsung Electronics retailer for purchasing.
You must use a wireless IP sharer that supports IEEE 802.11 a/b/g/n. (n is recommended for stable operation of the wireless network.)
Wireless LAN, by its nature, may cause interference, depending on the use condition (AP performance, distance, obstacles, interference by other radio devices, etc).
Set the wireless IP sharer to Infrastructure mode.
When applying the security key for the AP (wireless IP sharer), only the following is supported.
1)Authentication Mode : WEP, WPAPSK, WPA2PSK
2)Encryption Type : WEP, AES
For the AllShare function, a PC must be connected in the network as shown in the figure.
Attaching the Toroidal Ferrite Core to the Speaker Cables of the Main Unit
If you attach a Toroidal ferrite core to the Speaker Cables of the man unit, it will help to prevent RF interference from radio signals.
1.Pull the fixing tab of the Toroidal ferrite core to open it.
2.Make a loop once in the Speaker Cables.
3.Attach the Toroidal ferrite core to the Speaker Cables of the Main Unit as the figure shows and press it until it clicks.
FM ANT
WIRELESS
iPod
SPEAKER IMPEDANCE : 3